Activity
 
Notifications
Clear all
Carl A
Carl A
Group: Registered
Joined: 2017/06/12
Estimable Member
4
Interesting that it happened after a new firmware update las...

In forum Hardware, firmware and software help

1 year ago
Tim, Measurement was done out of circuit. Karl, you were rig...

In forum Hardware, firmware and software help

1 year ago
Tim - The voltage at the input to board for bed is 12.6 VDC....

In forum Hardware, firmware and software help

1 year ago
Top and bottom of bed look as good as new.

In forum Hardware, firmware and software help

1 year ago
yes, verified all fuses - all read zero ohms and are visuall...

In forum Hardware, firmware and software help

1 year ago
Here it is: I had and used a spare connector and attached me...

In forum Hardware, firmware and software help

1 year ago
Here it is: I had and used a spare connector and attached me...

In forum Hardware, firmware and software help

1 year ago
This is the second board with same problem. I would hate to ...

In forum Hardware, firmware and software help

1 year ago
Here goes: The bed LED is NOT on at any time which would ind...

In forum Hardware, firmware and software help

1 year ago
Tim-M30, I have sent all the readings to Ultimachine as I am...

In forum Hardware, firmware and software help

1 year ago
All fuses are OK and so are all connections. PSU is working ...

In forum Hardware, firmware and software help

1 year ago
I have emailed Ultimachine technical but no response to date...

In forum Hardware, firmware and software help

1 year ago
I moved this discussion to a new post "Bed Thermal Runaway"

In forum General discussion, announcements and releases

1 year ago
Ok, here are some readings: Bed has no light on when set to ...

In forum Hardware, firmware and software help

1 year ago
Bed Thermal Runaway

In forum Hardware, firmware and software help

1 year ago
I hope this is not a problem with the Rambo Mini. Any sugges...

In forum General discussion, announcements and releases

1 year ago
Maybe I should start a new post on this as it has been a whi...

In forum General discussion, announcements and releases

1 year ago
I have a MK2.5S and a MK3S and both still do it. All I get w...

In forum Hardware, firmware and software help

1 year ago
Old slicer files for MK 2.5 and MK 3 to 2.5S and 3S

In forum General discussion, announcements and releases

1 year ago
After downloading the stl files I really have more questions...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 year ago
Page 2 / 6
Share: