Notifications
Clear all
DerBierBaon
DerBierBaon
Group: Registered
Joined: 2017/05/31
Eminent Member
2
Bontech Gears: Difference between Prusa Shop and Bondtech Sh...

In forum Hardware, firmware and software help

3 months ago
I believe I get what you mean, but the 25mm³ cubes were just...

In forum Print tips (Archive)

2 years ago
The way I've calibrated linear advance so far was solely by ...

In forum Print tips (Archive)

2 years ago
Hi there, I own a Prusa MK2.5S and I am experiencing the e...

In forum Print tips (Archive)

2 years ago
Hey there, I experienced the same holes and I agree the rig...

In forum Print tips (Archive)

3 years ago
Hey Joan, thanks for the reply. Yes after some research I f...

In forum Hardware, firmware and software help

3 years ago
Rerouting electronics outside of enclosure

In forum Hardware, firmware and software help

3 years ago
So will the merge appear in the next iteration of the firmwa...

In forum Hardware, firmware and software help

4 years ago
Hi there, yes richard.l is right. What I'd like to make is ...

In forum Hardware, firmware and software help

4 years ago
Thanks for the reply. But that seems to be a problem though...

In forum Hardware, firmware and software help

4 years ago
Question regarding conditional gcoding with Slic3r PE

In forum Hardware, firmware and software help

4 years ago
So here's another update: I've managed to go through 1.5 fu...

In forum Hardware, firmware and software help

4 years ago
G80 is mesh bed levelling and G81 is the readout via pronter...

In forum Hardware, firmware and software help

4 years ago
Hey there, I too have these bubbles on my plate 🙂 (using t...

In forum General discussion, announcements and releases

4 years ago
Cool info thanks! Yeah black cap and black cable here... l...

In forum Hardware, firmware and software help

4 years ago
Grey or black as in color of the head of the PINDA? The hea...

In forum Hardware, firmware and software help

4 years ago
A little update on my issue: I still have the live-z fluctu...

In forum Hardware, firmware and software help

4 years ago
Hello again, leider nicht ganz 🙂 Yes, I actually reset th...

In forum Hardware, firmware and software help

4 years ago
Hey folks, first off: cudos to you Stahlfabrik, you've done...

In forum Hardware, firmware and software help

4 years ago
Hi there, regarding your x-axis rattling: I had the same is...

In forum Assembly and first prints troubleshooting

4 years ago
Page 1 / 2
Share: