Notifications
Clear all
CowboyHenk
CowboyHenk
Group: Registered
Joined: 2017/05/31
Active Member
1
Thanks!! In my case I used a second 24 volt power supply, bu...

In forum Hardware, firmware and software help

3 months ago
My problem returned...Also tried a separate power supply for...

In forum Hardware, firmware and software help

3 months ago
How did you do the wiring? I'm trying to solve a power issue...

In forum Hardware, firmware and software help

3 months ago
I had this problem as wel, tested cables and eveything seeme...

In forum Hardware, firmware and software help

5 months ago
I also had a lot of trouble...but figured out some things......

In forum Hardware, firmware and software help

1 year ago
As it turns out the idler was not working anymore. So I've p...

In forum Assembly and first prints troubleshooting

1 year ago
Alle red led lights blinking during print

In forum Assembly and first prints troubleshooting

1 year ago
PRO tip for all the MMUS2S upgrades...

In forum Assembly and first prints troubleshooting

3 years ago
It seems that al the bigger prints stop feeding filament at ...

In forum Assembly and first prints troubleshooting

3 years ago
for some reason the pinout is reversed from the einsy board:...

In forum Hardware, firmware and software help

3 years ago
My nozzle also hit the paper when calibrating xyz....lowerin...

In forum General discussion, announcements and releases

3 years ago
The problem most people have is due to the fact that the pul...

In forum Others (Archive)

3 years ago
Anyone already recieved their MK3 upgrade kit. And if so how...

In forum General discussion, announcements and releases

4 years ago
Anyone already recieved their MK3 upgrade kit. And if so how...

In forum General discussion, announcements and releases

4 years ago
I unpacked the MK3, put it on my perfectly matching anti-vib...

In forum General discussion, announcements and releases

4 years ago
A better MCU will allow to run at more stepsper mm, so round...

In forum General discussion, announcements and releases

4 years ago
For real? 500 € and we have to print all the parts ourselves...

In forum Others (Archive)

4 years ago
Finish of the Prusa Printer Parts

In forum Others (Archive)

4 years ago
Share: