Clarmrrsn
Clarmrrsn
Group: Registered
Joined: 2021/02/20
Honorable Member
1
@onur-inci Your motor pulley actually looks very close to th...

In forum Hardware, firmware and software help

2 days ago
It is normal as fushr says. This occurs when a measurment o...

In forum Hardware, firmware and software help

3 days ago
According to the info I read from prusa this is normal. They...

In forum Hardware, firmware and software help

3 days ago
@yakurbe Please dont, as suggested above "push the broken co...

In forum Hardware, firmware and software help

5 days ago
You also have the option of live chat support with Prusa. If...

In forum Hardware, firmware and software help

5 days ago
I would suggest inspecting the cabling around the hotend, th...

In forum Hardware, firmware and software help

5 days ago
Your images are not appearing, so difficult to assist. At a ...

In forum Assembly and first prints troubleshooting

7 days ago
If this is an issue (Difficult to say without hearing it, ma...

In forum Assembly and first prints troubleshooting

7 days ago
Give the grubs a good nip up, but dont over tighten them. T...

In forum Hardware, firmware and software help

1 week ago
Cant wait to see the XL. I have a feeling there will be some...

In forum General discussion, announcements and releases

1 week ago
Make sure one of the grub screws is tightened onto the flat ...

In forum Hardware, firmware and software help

1 week ago
@minormatt My printer was given tracking on Thursday and I r...

In forum General discussion, announcements and releases

1 week ago
Have you worked through this document. Not sure if anything ...

In forum Assembly and first prints troubleshooting

1 week ago
The only other thing to consider on longer prints is the env...

In forum Hardware, firmware and software help

1 week ago
Coil whine is USUALLY not harmful, it is just coils in certa...

In forum Hardware, firmware and software help

1 week ago
Also enable 7x7 with 5 reads at each point Mesh Bed levellin...

In forum Assembly and first prints troubleshooting

1 week ago
You are not low enough. Re check your SPINDA probe adjust ag...

In forum Assembly and first prints troubleshooting

1 week ago
The period is used in a filenane to signify a separator betw...

In forum Hardware, firmware and software help

1 week ago
Let us know how it works out please.

In forum Hardware, firmware and software help

1 week ago
Also, the wipes are not great, not enough IPA to clean, you ...

In forum Assembly and first prints troubleshooting

1 week ago
Page 1 / 26
Share:

Please Login or Register