Notifications
Clear all
danielkrah
danielkrah
Group: Registered
Joined: 2017/04/23
Eminent Member
2
i am using this fork and configured it to match my needs. ...

In forum Hardware, firmware and software help

6 months ago
I am using 3.9.0 on my MK2. I switched to 24v and now use a ...

In forum Hardware, firmware and software help

6 months ago
Works for me with a MK42, MKS gen 1.4, Pinda2 probe. I didn'...

In forum Hardware, firmware and software help

12 months ago
RE: Auf der Suche nach einem Lieferanten für maßgeschneidert...

In forum Allgemeine Diskussion, Ankündigungen und Veröffentlichungen

1 year ago
normally it should have worked with 3.9.0 but prusa research...

In forum Hardware, firmware and software help

1 year ago
just checkout the older commit of the file and you are good ...

In forum Hardware, firmware and software help

2 years ago
@karl-herbert Ja diese Folie wird auch bei den Prusa Pei Fol...

In forum Hilfe zur Hardware, Firmware und Software

2 years ago
Ah ok Danke für die Rückmeldung. Dann funktioniert es bei de...

In forum Hilfe zur Hardware, Firmware und Software

2 years ago
Ja das auf dem Bild ist eine original Pei folie von Prusa. A...

In forum Hilfe zur Hardware, Firmware und Software

2 years ago
ok hatte das Heizbed damals wohl höher 120-130 aufgeheizt (J...

In forum Hilfe zur Hardware, Firmware und Software

2 years ago
Halt aufpassen das man sich nicht die Flossen verbrennt 😉 ...

In forum Hilfe zur Hardware, Firmware und Software

2 years ago
Warum quält sich jeder mit dem froster und DLimonene rum? We...

In forum Hilfe zur Hardware, Firmware und Software

2 years ago
No, i use a MKS Gen 1.4 board with TMC2100 drivers + Should...

In forum General discussion, announcements and releases

2 years ago
the dying mainboard could have been the perfect point to cha...

In forum Hardware, firmware and software help

2 years ago
You can also buy a MKS gen 1.4 / L and use and tmc 2100 ste...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
RE: mk3s fan duct

In forum Improvements (Archive)

2 years ago
Ah ok it is sacrificial print support. I have the problem wh...

In forum General discussion, announcements and releases

2 years ago
I use the old knob from the i think it is the mk1

In forum Improvements (Archive)

2 years ago
Hi you have to comment this two lines out: as far i underst...

In forum Hardware, firmware and software help

2 years ago
they use fixed point sooo you can wait forever ....

In forum Others (Archive)

2 years ago
Page 1 / 2
Share: