Pecadis
Pecadis
Group: Registered
Joined: 2021/02/04
Active Member
1
@JoanTabb i absolutely agree with your statement, everybody'...

In forum Hardware, firmware and software help

1 month ago
@Joantabb i think it would make sense for the technicians to...

In forum Hardware, firmware and software help

1 month ago
Doesn't sound that good as well. :-/ Thank you for the Disco...

In forum Hardware, firmware and software help

1 month ago
I am frustrated with the MMU2S

In forum Hardware, firmware and software help

1 month ago
Update:The heat creep was only a part of this issue. I found...

In forum Hardware, firmware and software help

2 months ago
After countless hours of bugfixing and trial and error, i fo...

In forum Hardware, firmware and software help

2 months ago
Hi there, i would recommend you to take a look into the offi...

In forum Hardware, firmware and software help

2 months ago
Filament Jam when unloading (it's not the common ones, i gue...

In forum Hardware, firmware and software help

2 months ago
@cwbullet, actually, it wasn't directly the screw in my case...

In forum Hardware, firmware and software help

3 months ago
Yes, it was the y-axis idler =)Fixed now

In forum Hardware, firmware and software help

3 months ago
Hi Misan, thanks for your suggestions, i was suspecting the ...

In forum Hardware, firmware and software help

3 months ago
Ok, i have loosened the steppermotor from the carriage, movi...

In forum Hardware, firmware and software help

3 months ago
yes, it is indeed clean. I have stopped the Print now and co...

In forum Hardware, firmware and software help

3 months ago
Really weird squeaky noises while printing

In forum Hardware, firmware and software help

3 months ago
Share:

Please Login or Register