Activity
 
Lung
Lung
Group: Registered
Joined: 2021/01/29
Eminent Member
2
@karl-herbert I did it with some small diamond files. Took a...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 months ago
I bought these and also got non-pass-through fittings. I'm g...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 months ago
@cwbullet CUI make a 10mm fan with a higher throughput but i...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 months ago
It seems that Delta make the highest CFM fans in this size, ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 months ago
Noctua are known for being quiet but not with the highest co...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 months ago
I have just noticed that in the Solex photos of the I3 nozzl...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 months ago
RE: Different Hotends

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 months ago
OK now I'm really confused, I contacted Solex and they say t...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 months ago
@bobstro Thanks for that. The nozzles i have are 6.4mm, so a...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 months ago
@bobstro Could you measure one of your nozzles from tip to e...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 months ago
@bobstro No I didn't get the Prusa set, I got thesewhich I n...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 months ago
I've run into problems on my mini with the solex nozzles, na...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 months ago
This seems like a good idea so I've ordered the .4 and .8 no...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 months ago
Good point, I hadn't considered that and have had a quick lo...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 months ago
Actually the Dragon high flow is the same price as a Dragonf...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 months ago
Which have you used, the Copperhead or the Dragonfly? I read...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 months ago
No, I've not purchased it yet. The Dragonfly is considerably...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 months ago
I'm wondering if Jasii's Copperhead mount would be suitable,...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 months ago
Has anyone seen a mount for a Phaetus Dragonfly for the Mini...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 months ago
Does your Pi not get too hot inside the enclosure? I'm looki...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 months ago
Page 1 / 2
Share:

Please Login or Register