Notifications
Clear all
technogeeky
technogeeky
Group: Registered
Joined: 2021/01/25
Eminent Member
2
@owt-from-nowt The other day, I used a very accurate thermom...

In forum General discussion, announcements and releases

5 months ago
@owt-from-nowt If you can only print very good PLA like that...

In forum General discussion, announcements and releases

5 months ago
Likewise, I have to think about the logic for this every tim...

In forum Assembly and first prints troubleshooting

5 months ago
This post may actually be describing two different issues. T...

In forum Assembly and first prints troubleshooting

5 months ago
If you could also provide pictures of the underextuded print...

In forum General discussion, announcements and releases

5 months ago
OK. Thank you. So my questions about the OP are: why did you...

In forum General discussion, announcements and releases

5 months ago
I have a NIST calibrated thermometer; I will check mine and ...

In forum General discussion, announcements and releases

5 months ago
For people reading this who are considering buying one, I th...

In forum General discussion, announcements and releases

5 months ago
I measured it down where I expect the bulk of filament in th...

In forum General discussion, announcements and releases

5 months ago
@oxygen When you do figure it out, I'd love to know. I have ...

In forum General discussion, announcements and releases

5 months ago
Speaking of fans and fan shrouds, is the part cooling fan on...

In forum General discussion, announcements and releases

5 months ago
@cwbullet I wasn't doing anything other than possibly physic...

In forum General discussion, announcements and releases

5 months ago
While the printer is mostly working fine, I also wanted to c...

In forum General discussion, announcements and releases

5 months ago
I used it last night; it's working fine for me. Reset the IP...

In forum General discussion, announcements and releases

5 months ago
I purchased another device from Amazon that was cheaper, cla...

In forum General discussion, announcements and releases

5 months ago
@zoltan M600 does work just fine. The various OctoPrint plug...

In forum General discussion, announcements and releases

6 months ago
I am still using the stock firmware; but the main gripe I ha...

In forum General discussion, announcements and releases

6 months ago
@ra-ma So OctoPrint works fine, but it sits idle at the Prus...

In forum General discussion, announcements and releases

6 months ago
Re: the bouncing issue as I described and the PINDA levellin...

In forum Assembly and first prints troubleshooting

6 months ago
I have a Prusa MINI+ and used a similar technique to trouble...

In forum Assembly and first prints troubleshooting

6 months ago
Share: