Activity
 
Notifications
Clear all
Lucas
Lucas
Group: Registered
Joined: 2021/01/20
Active Member
1
Sure thing, 1. MMU for single prints 2. 3D Fuel PLA+ 1.75mm ...

In forum Hardware, firmware and software help

4 months ago
MMU Needs Attention after every print.

In forum Hardware, firmware and software help

4 months ago
Appreciate both your help, and the nice thing about OpenSCAD...

In forum PrusaSlicer

8 months ago
Looks like I was missing something. It's the use of the mink...

In forum PrusaSlicer

8 months ago
OpenSCAD Base Sizing

In forum PrusaSlicer

8 months ago
Set a height to surfaces layer?

In forum PrusaSlicer

8 months ago
Thanks to both of you, I gave it a good washing with dawn an...

In forum How do I print this? (Printing help)

9 months ago
Is there something wrong with the print settings in this 3MF...

In forum How do I print this? (Printing help)

9 months ago
I attached the GCode I used to print.This is the STL I based...

In forum How do I print this? (Printing help)

10 months ago
How to fix a lack of filament at the seams in vase mode?

In forum How do I print this? (Printing help)

10 months ago
@stewartr I am one step behind on the firmware (3.9.3) which...

In forum Assembly and first prints troubleshooting

10 months ago
@stewartr Well there was definitely something wrong with the...

In forum Assembly and first prints troubleshooting

10 months ago
RE: First Layer Calibration: MMU2S constantly loads and unlo...

In forum Assembly and first prints troubleshooting

10 months ago
Another day another problem, and I'm beginning to think that...

In forum Assembly and first prints troubleshooting

10 months ago
I am using the silver filament that came with the printer fo...

In forum Assembly and first prints troubleshooting

10 months ago
RE: First Layer Calibration: MMU2S constantly loads and unlo...

In forum Assembly and first prints troubleshooting

10 months ago
@robin I think the problem is where the clear tubes out of t...

In forum Assembly and first prints troubleshooting

11 months ago
First Layer Calibration: MMU2S constantly loads and unloads ...

In forum Assembly and first prints troubleshooting

11 months ago
Share: