Activity
 
Notifications
Clear all
Lucas
Lucas
Group: Registered
Joined: 2021/01/20
Active Member
1
Sure thing, 1. MMU for single prints 2. 3D Fuel PLA+ 1.75mm ...

In forum Hardware, firmware and software help

3 months ago
MMU Needs Attention after every print.

In forum Hardware, firmware and software help

3 months ago
Appreciate both your help, and the nice thing about OpenSCAD...

In forum PrusaSlicer

7 months ago
Looks like I was missing something. It's the use of the mink...

In forum PrusaSlicer

7 months ago
OpenSCAD Base Sizing

In forum PrusaSlicer

7 months ago
Set a height to surfaces layer?

In forum PrusaSlicer

7 months ago
Thanks to both of you, I gave it a good washing with dawn an...

In forum How do I print this? (Printing help)

8 months ago
Is there something wrong with the print settings in this 3MF...

In forum How do I print this? (Printing help)

8 months ago
I attached the GCode I used to print.This is the STL I based...

In forum How do I print this? (Printing help)

9 months ago
How to fix a lack of filament at the seams in vase mode?

In forum How do I print this? (Printing help)

9 months ago
@stewartr I am one step behind on the firmware (3.9.3) which...

In forum Assembly and first prints troubleshooting

9 months ago
@stewartr Well there was definitely something wrong with the...

In forum Assembly and first prints troubleshooting

9 months ago
RE: First Layer Calibration: MMU2S constantly loads and unlo...

In forum Assembly and first prints troubleshooting

9 months ago
Another day another problem, and I'm beginning to think that...

In forum Assembly and first prints troubleshooting

9 months ago
I am using the silver filament that came with the printer fo...

In forum Assembly and first prints troubleshooting

9 months ago
RE: First Layer Calibration: MMU2S constantly loads and unlo...

In forum Assembly and first prints troubleshooting

9 months ago
@robin I think the problem is where the clear tubes out of t...

In forum Assembly and first prints troubleshooting

9 months ago
First Layer Calibration: MMU2S constantly loads and unloads ...

In forum Assembly and first prints troubleshooting

9 months ago
Share: