Notifications
Clear all
Richard D
Richard D
Group: Registered
Joined: 2021/01/09
Eminent Member
2
do you mean that it's confirmed that you CANNOT remove the f...

In forum General discussion, announcements and releases

1 month ago
FWIW, after moving the SuperPINDA several times (as well as ...

In forum Assembly and first prints troubleshooting

1 month ago
Having had two go now, I keep a spare thermistor & cable...

In forum Hardware, firmware and software help

1 month ago
A new delivery of filament -including the previously "discon...

In forum How do I print this? (Printing help)

1 month ago
I’m not normally fussed about trying to get things dialled i...

In forum How do I print this? (Printing help)

1 month ago
Still pretty shocking behaviour from the current filament. ...

In forum How do I print this? (Printing help)

1 month ago
Well, the Z-layer height - and first layer - were as I suspe...

In forum How do I print this? (Printing help)

1 month ago
The weird thing is that I’d given the bed a proper clean wit...

In forum How do I print this? (Printing help)

1 month ago
Weird issue - see attached pic

In forum How do I print this? (Printing help)

1 month ago
@cwbullet Yep, been using something like that since the last...

In forum Hardware, firmware and software help

3 months ago
Heatbed thermistor wire breaking

In forum Hardware, firmware and software help

3 months ago
The Future floor polish is essentially a (weak-ish) acrylic ...

In forum General discussion, announcements and releases

4 months ago
Yup; looks like your nozzle is too high; use Live Adjust Z t...

In forum Assembly and first prints troubleshooting

4 months ago
@towlerg The software I was referring to is the slicer; that...

In forum General discussion, announcements and releases

4 months ago
Z-axis adjust "drift"?

In forum Assembly and first prints troubleshooting

4 months ago
I purchased a Sandisk wifi stick precisely for the Mini (as ...

In forum General discussion, announcements and releases

4 months ago
I have the same problem - that my Mini clicks (didn't realis...

In forum Assembly and first prints troubleshooting

6 months ago
Good points. I've printed most of your design, which by som...

In forum Hardware, firmware and software help

7 months ago
Interesting! I knocked up something similar in terms of sup...

In forum Hardware, firmware and software help

7 months ago
Ho ho. Mine's just gone after just under 4 weeks of ownersh...

In forum Hardware, firmware and software help

7 months ago
Page 1 / 2
Share: