Notifications
Clear all
Martin010
Martin010
Group: Registered
Joined: 2020/12/29
Active Member
1
Ok Thanks for you great help. I purchased an MK3 in April 20...

In forum General discussion, announcements and releases

3 months ago
Greatly appreciated!

In forum General discussion, announcements and releases

3 months ago
The print is a basic 80mm circle to be a rubber cap. File is...

In forum General discussion, announcements and releases

3 months ago
So tweaked it more, changed the volumetric speed to match, g...

In forum General discussion, announcements and releases

3 months ago
Here is some info regarding the TPU brand, maybe this helps?

In forum General discussion, announcements and releases

3 months ago
It's Flex filament TPU 500g HotOrange3D, has a temperature r...

In forum General discussion, announcements and releases

3 months ago
So, tried the printer settings, did got further improvement,...

In forum General discussion, announcements and releases

3 months ago
Thanks Will have a go with that.

In forum General discussion, announcements and releases

3 months ago
@ssill2, can you provide me with your slicers settings? I a...

In forum General discussion, announcements and releases

3 months ago
Had a moment to try, slightly better, that is instead of 5mi...

In forum How do I print this? (Printing help)

4 months ago
Hi, Old topic, but I have the same issues, and not sure wh...

In forum General discussion, announcements and releases

4 months ago
Thanks all for the tips. Not at home for a few days, will gi...

In forum How do I print this? (Printing help)

4 months ago
Right so divided here.. don't touch the idler, or do change ...

In forum How do I print this? (Printing help)

4 months ago
MK3S+ Issues with TPU Printing

In forum How do I print this? (Printing help)

4 months ago
Calibration failure after nozzle change

In forum Hardware, firmware and software help

11 months ago
Share: