Notifications
Clear all
MrBleadd
MrBleadd
Group: Registered
Joined: 2020/12/27
Active Member
1
@tim-2 Ah okay, so your rods do have some smaller scratches ...

In forum Hardware, firmware and software help

7 months ago
It is a weird question but replacing rods and bearings every...

In forum Hardware, firmware and software help

7 months ago
@tim-2 How often do you have to replace rods and bearings in...

In forum Hardware, firmware and software help

7 months ago
@tim-2 I already measured a deflection, it is slightly outsi...

In forum Hardware, firmware and software help

7 months ago
@tim-2 so I guess I have to reprint these parts? At the mome...

In forum Hardware, firmware and software help

7 months ago
@tim-2 okay yeah I measured it, it's 0.01 mm

In forum Hardware, firmware and software help

7 months ago
@tim-2 So it should be good to check if that’s the case (if ...

In forum Hardware, firmware and software help

7 months ago
@tim-2 There is actually always a bit grayish black residue

In forum Hardware, firmware and software help

7 months ago
Yeah that is what I also found after searching through the f...

In forum Hardware, firmware and software help

7 months ago
@tim-2 Prusa shipped me some with the new rods. I degreased ...

In forum Hardware, firmware and software help

7 months ago
Today the same happened to me too. Just a normal print, then...

In forum Hardware, firmware and software help

7 months ago
@todd-martineau I hope that works for you and you can start ...

In forum Hardware, firmware and software help

11 months ago
Okay, today I tried the other recommendations, but they also...

In forum Hardware, firmware and software help

11 months ago
I have the same Problem The day before I did the Firmware up...

In forum Hardware, firmware and software help

12 months ago
Share: