Activity
 
Notifications
Clear all
Tobbe
Tobbe
Group: Registered
Joined: 2020/12/25
Active Member
1
Sorry for the stupid question, but what is the real problem ...

In forum Hardware, firmware and software help

4 months ago
If it says crash detected then that's what has happened and ...

In forum Hardware, firmware and software help

4 months ago
I still don't think the nylock mod is needed, in your case a...

In forum Hardware, firmware and software help

5 months ago
you can probably add a modifier object, make sure it covers ...

In forum Hardware, firmware and software help

6 months ago
A few things. I assume you took apart the whole hotend inclu...

In forum Hardware, firmware and software help

6 months ago
To answer your initial question, no i don't think you can mo...

In forum Hardware, firmware and software help

6 months ago
If printer for example is using filament 1 then number 2 won...

In forum Hardware, firmware and software help

6 months ago
Try: Print Settings tab, then Multiple Extruders and set "Su...

In forum Hardware, firmware and software help

6 months ago
@cwbullet I'm not new to 3d printing, i've had the printer ...

In forum Hardware, firmware and software help

6 months ago
Accuracy of the extruder temp sensor

In forum Hardware, firmware and software help

6 months ago
Thanks removing "don't support bridges" did the trick

In forum PrusaSlicer

8 months ago
Forcing supports in areas the slicer refused to put supports

In forum PrusaSlicer

8 months ago
In my experience if bed is is tilted left or right when you ...

In forum Hardware, firmware and software help

10 months ago
If you end up having to remove (or replace) the heatbreak an...

In forum General discussion, announcements and releases

10 months ago
I know this is an obvious question but have you cleaned the ...

In forum General discussion, announcements and releases

10 months ago
2.3.0-rc2 and multimaterial issues

In forum PrusaSlicer

12 months ago
Share: