DarkKnight
DarkKnight
Group: Registered
Joined: 2020/12/13
Active Member
1
FINDA probe behaving erratically

In forum Hardware, firmware and software help

2 months ago
For the life of me I could not get the factory supplied PETG...

In forum Hardware, firmware and software help

3 months ago
@paulhostettler 3D printing, IMHO, is not exactly a casual h...

In forum Hardware, firmware and software help

3 months ago
@towlerg I do use octoprint, but even bypassing this process...

In forum Hardware, firmware and software help

3 months ago
I would start by examining the voltages on your PSU while th...

In forum Hardware, firmware and software help

3 months ago
A few things that come to mind are (in approximate order of ...

In forum Hardware, firmware and software help

3 months ago
It looks like you are using non-standard equipment, so it's ...

In forum Hardware, firmware and software help

3 months ago
So I literally cannot get the slicer to output code that the...

In forum Hardware, firmware and software help

3 months ago
I should add to this that on top of everything else, there i...

In forum Hardware, firmware and software help

3 months ago
Problems with Prusa Slicer usability

In forum Hardware, firmware and software help

3 months ago
Thank you everyone, particularly @joantabb, for the informed...

In forum General discussion, announcements and releases

4 months ago
@karl-herbert What holding current is necessary for motors t...

In forum General discussion, announcements and releases

4 months ago
Z axis motors warm when idle

In forum General discussion, announcements and releases

4 months ago
Share:

Please Login or Register