Notifications
Clear all
raymate
raymate
Group: Registered
Joined: 2020/12/10
Estimable Member
4
interesting

In forum Hardware, firmware and software help

5 months ago
Bed levelling does not correct fully....

In forum Hardware, firmware and software help

5 months ago
What causes this on my prints.....

In forum General discussion, announcements and releases

6 months ago
@fuchsr I used this one and worked a treat, I love how I can...

In forum General discussion, announcements and releases

6 months ago
@fuchsr Nice I printed said calibration tool, used it and no...

In forum General discussion, announcements and releases

6 months ago
You are spot on I just did chat with support they said use z...

In forum General discussion, announcements and releases

6 months ago
Interesting, I set mine with a credit card, maybe thats to t...

In forum General discussion, announcements and releases

6 months ago
@tdashadow Oh thats not good, lets hope Prusa can change the...

In forum General discussion, announcements and releases

6 months ago
Mine also does the same, mine is a few weeks old. I cant see...

In forum General discussion, announcements and releases

6 months ago
Satin sheet I cannot calibrate I have hit the -2.0 limit..

In forum General discussion, announcements and releases

6 months ago
That was the same for me, after spending some time on chat w...

In forum General discussion, announcements and releases

6 months ago
Thats a shame

In forum General discussion, announcements and releases

6 months ago
Does mini track total hours used?

In forum General discussion, announcements and releases

7 months ago
So mine is fixed, after a week of owning it from new I got t...

In forum How do I print this? (Printing help)

7 months ago
@cashew92ftw Thanks for the pic, im sold, signed up to be no...

In forum General discussion, announcements and releases

7 months ago
@cashew92ftw So is it smooth or a bit textured. Yes Iv not e...

In forum General discussion, announcements and releases

7 months ago
So we can get 3 different sheet now for the Mini ? I ordered...

In forum General discussion, announcements and releases

7 months ago
So mine is fixed, after a week of owning it from new I got t...

In forum Assembly and first prints troubleshooting

7 months ago
Any reason why just no engaged detect thin walls all the tim...

In forum PrusaSlicer

7 months ago
On the mini what increments should I be using to get the ini...

In forum Assembly and first prints troubleshooting

7 months ago
Page 1 / 7
Share: