Notifications
Clear all
Dan Rogers
Dan Rogers
Group: Registered
Joined: 2020/12/01
Noble Member
3
Time for a roll back.

In forum Hardware, firmware and software help

11 hours ago
Assuming you have not been keeping the firmware synced .. l...

In forum Hardware, firmware and software help

11 hours ago
If you need flexibility, ABS is not the way to go. It's har...

In forum How do I print this? (Printing help)

11 hours ago
No photos were harmed in making this thread.

In forum How do I print this? (Printing help)

11 hours ago
Yes those get sliced in - you can see them in the slicer pre...

In forum Assembly and first prints troubleshooting

1 day ago
I believe the context for that calculator is what to charge ...

In forum General discussion, announcements and releases

2 days ago
I do not recommend using Octoprint pause - it just stops the...

In forum General discussion, announcements and releases

2 days ago
I use a filament guide too - a wide one that allows the extr...

In forum General discussion, announcements and releases

2 days ago
I'll just leave that there (post title). If you are getting...

In forum Hardware, firmware and software help

3 days ago
Whomever's picture above with the screw barely seated in the...

In forum Hardware, firmware and software help

3 days ago
Is there a knotted spool situation causing your prints to ja...

In forum Hardware, firmware and software help

3 days ago
Looks like you have not got Z dialed in.

In forum Assembly and first prints troubleshooting

3 days ago
So you CAN select with the knob but you CAN'T select with th...

In forum Assembly and first prints troubleshooting

3 days ago
Was this PLA? Assuming you printed the stock GCODE on the S...

In forum Assembly and first prints troubleshooting

3 days ago
On that comment about the spool having to spin absolutely fr...

In forum General discussion, announcements and releases

3 days ago
Start with eliminating resonance transmission. Go to the pr...

In forum Assembly and first prints troubleshooting

3 days ago
Let's see that bottom layer - it's the first thing you will ...

In forum Assembly and first prints troubleshooting

3 days ago
If it was just sitting with no heating for a spell, and then...

In forum Assembly and first prints troubleshooting

3 days ago
You can test for moisture when you load filament. You load ...

In forum Assembly and first prints troubleshooting

3 days ago
Be sure to provide a test case that shows the problem.

In forum Hardware, firmware and software help

3 days ago
Page 1 / 62
Share: