Notifications
Clear all
TeachThePrints
TeachThePrints
Group: Registered
Joined: 2020/11/18
Eminent Member
2
Prusa released a belt tensioner print, which is quite easy t...

In forum Assembly and first prints troubleshooting

10 months ago
What time constraints do you have? If the build fits onto a ...

In forum General discussion, announcements and releases

11 months ago
Yeah, the instructions should be updated to say that 2 credi...

In forum Assembly and first prints troubleshooting

11 months ago
If it fits on the holder and the holder stands solid, printi...

In forum General discussion, announcements and releases

11 months ago
^ That was me not realizing, that the hotend heater wires ha...

In forum Assembly and first prints troubleshooting

11 months ago
Missed the edit time, hence a new post Below is a picture, w...

In forum Assembly and first prints troubleshooting

11 months ago
If you have cleaning filament, (some spools come with it) us...

In forum Assembly and first prints troubleshooting

11 months ago
How to remove the buddy board?

In forum Assembly and first prints troubleshooting

11 months ago
It was my understanding, the printer cannot be powered throu...

In forum Hardware, firmware and software help

11 months ago
Can you guys fix the download link in the first post? The de...

In forum PrusaSlicer

11 months ago
^ That's not something you can avoid, unless you add more pe...

In forum How do I print this? (Printing help)

11 months ago
The slicer probably intends to bridge that upper section. De...

In forum How do I print this? (Printing help)

11 months ago
The only tools I use with the mini are: diagonal cutters: to...

In forum General discussion, announcements and releases

11 months ago
Might be, that the layer time is too low, if this issue only...

In forum How do I print this? (Printing help)

11 months ago
The probes have a label attached to the wireending inside th...

In forum General discussion, announcements and releases

11 months ago
Thanks for the clarification. Initially, I had printed via O...

In forum Hardware, firmware and software help

11 months ago
Pause print message not showing?

In forum Hardware, firmware and software help

11 months ago
Found working parameters. a) keep the bottomlayers thin, the...

In forum How do I print this? (Printing help)

11 months ago
Why does the mini have lower max layer height?

In forum Hardware, firmware and software help

11 months ago
There seems to be an issue, where the magnets are attracted ...

In forum How do I print this? (Printing help)

11 months ago
Page 1 / 2
Share: