Activity
 
Notifications
Clear all
egar
egar
Group: Registered
Joined: 2020/11/15
Estimable Member
4
Sounds to me like two pieces vibrating together. I've seen ...

In forum Assembly and first prints troubleshooting

1 week ago
I think the Filastruder Veracity orange PETG to be an exact ...

In forum General discussion, announcements and releases

1 month ago
If height is an issue, perhaps try one of the many squash ba...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 months ago
@fuchsr My only power problems are self-induced. Twice I ha...

In forum User mods - OctoPrint, enclosures, nozzles, ...

4 months ago
I'm sure there are likely other short-comings, but the only ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

4 months ago
That domain registration expired about 6 weeks ago. I looked...

In forum PrusaSlicer

4 months ago
If the reset that @bobstro mentions does not help you, then ...

In forum PrusaSlicer

4 months ago
Any info on PrusaLink? So it supported by the slicer, but I...

In forum PrusaSlicer

4 months ago
@steveginusa and @cwbullet I did get my Paramount ASA dialed...

In forum How do I print this? (Printing help)

5 months ago
@steveginusa I appreciate your interest in my posts and some...

In forum How do I print this? (Printing help)

5 months ago
The recommendation for printing those parts is to rotate the...

In forum PrusaSlicer

5 months ago
@diem Thanks for the wet paper towel suggestion. I'll give ...

In forum How do I print this? (Printing help)

6 months ago
I use Windex because is it easy and cheap. Plus it does not...

In forum How do I print this? (Printing help)

6 months ago
The comments are very helpful. I would have never gotten th...

In forum Assembly and first prints troubleshooting

6 months ago
I will second that statement. I've been part of several thr...

In forum How do I print this? (Printing help)

6 months ago
I really like the designs. One of my biggest prints so far ...

In forum Awesome prints (Hall Of Fame)

6 months ago
@nick-cent I don't have the Bear upgrade, but I looked into ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

6 months ago
@a-awaji Looks like a classic example of the Z-axis being se...

In forum Hardware, firmware and software help

6 months ago
I'm not sure where I saw this, but I had a bookmark for this...

In forum General discussion, announcements and releases

6 months ago
That sound within the range of what is normal. Diagonal mov...

In forum Assembly and first prints troubleshooting

6 months ago
Page 1 / 6
Share: