Notifications
Clear all
kenny.b2
kenny.b2
Group: Registered
Joined: 2017/03/27
Trusted Member
3
Thanks for the clarification, that was the bit I was having ...

In forum Hardware, firmware and software help

2 years ago
@ian-s3 Moving the PINDA would be linear with respect to the...

In forum Hardware, firmware and software help

2 years ago
I don't think this is true or if it is, it isn't obvious in ...

In forum Hardware, firmware and software help

2 years ago
@ajisis That doesn't make sense though (coming from someone ...

In forum Hardware, firmware and software help

2 years ago
@ajisis I'm using the skew term generically in that your bed...

In forum Hardware, firmware and software help

2 years ago
@ian-s3 On the printer, go to support -> XYZ cal. details...

In forum Hardware, firmware and software help

2 years ago
@robert-h16 I have a bear frame so it was a little easier to...

In forum Hardware, firmware and software help

2 years ago
@pedro-c3 Yeah, I did. If you have any skew in the frame, i...

In forum Hardware, firmware and software help

2 years ago
@vintagepc With regard to the purging volumes, I wonder if y...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
@vintagepc Thanks for doing this! I'll give it a try too in...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
That's awesome! If you need someone to test your code, let ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
@allen-m2 I wish PrusaSlicer had some more functionality of ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
If you turn off the purge block and use their custom tool ch...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
I'm not getting any collisions with the cable or fan, there ...

In forum Hardware, firmware and software help

3 years ago
Not getting full X-axis travel mk2.5s

In forum Hardware, firmware and software help

3 years ago
I realize the post is almost a year old now but did you ever...

In forum Hardware, firmware and software help

3 years ago
I'm getting occasional layer shifts too. I noticed in the "...

In forum Hardware, firmware and software help

3 years ago
Octolapse snapshot settings

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 years ago
Looks like someone else also reported it. I was going t...

In forum General discussion, announcements and releases

3 years ago
I loaded this new firmware yesterday on my Mk2.5 with MMU2 (...

In forum General discussion, announcements and releases

3 years ago
Page 1 / 3
Share: