Notifications
Clear all
Zorro_X
Zorro_X
Group: Registered
Joined: 2020/11/08
Eminent Member
2
Any other suggestion about what can be the cause of my probl...

In forum Hardware, firmware and software help

3 weeks ago
I'm also having similar troubles since update from MK3S to M...

In forum Hardware, firmware and software help

4 weeks ago
I've tried previous gcode files and they works much better t...

In forum Hardware, firmware and software help

4 weeks ago
OK, but I've not flashed it since before the MK3S+ update : ...

In forum Hardware, firmware and software help

4 weeks ago
Hi, it is interesting, I have a similar problem here () but ...

In forum Hardware, firmware and software help

4 weeks ago
Thankyou, but I already do that : I've two sheets and each o...

In forum Hardware, firmware and software help

4 weeks ago
I've also tried to "cheat" by calibrating the Z height "on f...

In forum Hardware, firmware and software help

1 month ago
First layer flow problem

In forum Hardware, firmware and software help

1 month ago
ok, thankyou for the advices.I don't understand why this hap...

In forum Hardware, firmware and software help

11 months ago
@cwbullet I've tried octofiber and it was unable to stick to...

In forum Hardware, firmware and software help

11 months ago
@cwbullet nope, it seems to happen only with PET-G prints, b...

In forum Hardware, firmware and software help

11 months ago
@cwbullet ok, so when it is cold (so I can touch it) I don't...

In forum Hardware, firmware and software help

11 months ago
@cwbullet nope, and the belts are tight...

In forum Hardware, firmware and software help

11 months ago
X shift, Z not constant and play noise

In forum Hardware, firmware and software help

11 months ago
@tim-m30 hi, thankyou, I've got near the same tip from anoth...

In forum Hardware, firmware and software help

11 months ago
Filament stuck on top of PTFE

In forum Hardware, firmware and software help

11 months ago
@tim-m30 thankyou, I'm just finishing my octofiber filament ...

In forum How do I print this? (Printing help)

11 months ago
Hi, thankyou, i'll try 80°, but 90° clearly seems too hot fo...

In forum How do I print this? (Printing help)

11 months ago
Printing PET-G octofiber with i3 MK3S

In forum How do I print this? (Printing help)

11 months ago
Sorry, the problem was me. In my case everything is OK now.

In forum Assembly and first prints troubleshooting

12 months ago
Page 1 / 2
Share: