Activity
 
hli
hli
Group: Registered
Joined: 2020/11/06
Trusted Member
3
The PINDA probe look strange - it should be upright (perpend...

In forum How do I print this? (Printing help)

2 weeks ago
Most likely another case of. Best solution: flash 3.9.2 agai...

In forum Hardware, firmware and software help

3 weeks ago
The gitHub repo for the Einsy Rambohas a BOM list (at). J7 (...

In forum Hardware, firmware and software help

4 weeks ago
Which firmware version are you using ? (There is a known iss...

In forum Hardware, firmware and software help

1 month ago
Evt. dieses Problem hier:? Wenn ja - auf FW 3.9.2 zurückgehe...

In forum Zusammenbau und Fehlersuche bei den ersten Druckversuchen

1 month ago
What I meant with manual extrusion: heat the nozzle up (even...

In forum Hardware, firmware and software help

2 months ago
285°C might be too hot - PLA might start to degrade at this ...

In forum Hardware, firmware and software help

2 months ago
The nozzle will be 0.15mm above the bed after auto-homing (a...

In forum PrusaSlicer

2 months ago
The assumption for PrusaSlicer (and the MK3) is that with Z=...

In forum PrusaSlicer

2 months ago
Oben wurden schon die FreeCAD-Videos von Roland Frank erwähn...

In forum Hilfe zur Hardware, Firmware und Software

2 months ago
Does the stored Z-offset change between prints?One reason fo...

In forum Hardware, firmware and software help

2 months ago
RE: Super Pinda Alternativen

In forum Hilfe zur Hardware, Firmware und Software

2 months ago
I'd say too high. But look at, and print a first layer squar...

In forum Assembly and first prints troubleshooting

2 months ago
Put the printer on a stone paver or something heavy, and the...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 months ago
Easiest way to check for resonances: when printing, lift the...

In forum Hardware, firmware and software help

3 months ago
Probably another case of. For now going back to 3.9.2 seems ...

In forum Hardware, firmware and software help

3 months ago
Das Ritzel ist verkehrtherum aufgesetzt - die glatte Seite m...

In forum Zusammenbau und Fehlersuche bei den ersten Druckversuchen

3 months ago
Tip: Prusaslicer sagt beim Slicen wieviel Filament ein Objek...

In forum Hilfe zur Hardware, Firmware und Software

3 months ago
"Sorting files" indicates an inserted SD card. Is there one?...

In forum Hardware, firmware and software help

3 months ago
An SD card reader for the SD card slot?

In forum Assembly and first prints troubleshooting

3 months ago
Page 1 / 3
Share:

Please Login or Register