Forums
Members
paulhostettler
Activity
 
Notifications
Clear all
paulhostettler
paulhostettler
Group: Registered
Joined: 2020/10/31
Eminent Member
2
Profile Activity
Hey, I'm back! Both printers down again >

In forum Hardware, firmware and software help

 5 months ago
@clemens-m I really appreciate your assistance

In forum Hardware, firmware and software help

 8 months ago
@clemens-m Tried inputting that command, 5 minutes later, th...

In forum Hardware, firmware and software help

 8 months ago
Here's a short video of what's going on presently.

In forum Hardware, firmware and software help

 8 months ago
@clemens-m Hm, I installed Prontercace, connected it to my p...

In forum Hardware, firmware and software help

 8 months ago
@fuchsr Of course : )

In forum Hardware, firmware and software help

 8 months ago
I suspect when I updated the firmware, I erased the e-steppi...

In forum Hardware, firmware and software help

 8 months ago
@darkknight That sounds like a huge time and financial inves...

In forum Hardware, firmware and software help

 8 months ago
The next disaster: weak filament loading

In forum Hardware, firmware and software help

 8 months ago
Well that is quite the silly mistake! I’ll try fixing it thi...

In forum Hardware, firmware and software help

 8 months ago
Basically I can span from X=0 to X=254

In forum Hardware, firmware and software help

 8 months ago
Here’s a video of the x axis in action Attachment removed

In forum Hardware, firmware and software help

 8 months ago
Serious Z axis calibration

In forum Hardware, firmware and software help

 8 months ago
@joantabb Help my @joantabb, you’re my only hope! Also Prusa...

In forum Hardware, firmware and software help

 10 months ago
So I swapped in an SD card that another Prusa (#2) was able ...

In forum Hardware, firmware and software help

 11 months ago
Sometimes I wish there was like a service center I could jus...

In forum Hardware, firmware and software help

 11 months ago
I understood all that! Attachment removed

In forum Hardware, firmware and software help

 11 months ago
Eep, paste didn't work >.>  Prus-fault.jpg

In forum Hardware, firmware and software help

 11 months ago
@joantabb So those amazon bearings seemed to do the trick, a...

In forum Hardware, firmware and software help

 11 months ago
Page 1 / 3
Share: