mGoleta
mGoleta
Group: Registered
Joined: 2020/10/20
Eminent Member
2
I saw something similar. I rechecked the the 3 screws that ...

In forum Assembly and first prints troubleshooting

4 weeks ago
@craigb I only thought they updated approximately every 2 w...

In forum General discussion, announcements and releases

3 months ago
I posted the issue on the GITHUB site. It appears that a fi...

In forum General discussion, announcements and releases

3 months ago
Were is best place to respond with RC2 issue? I have RC2 loa...

In forum General discussion, announcements and releases

3 months ago
I assume that the picture you are showing does not have any ...

In forum Hardware, firmware and software help

3 months ago
The following PRUSA article has guidelines for the idler adj...

In forum Hardware, firmware and software help

3 months ago
Just some thoughts. Have you changed the table the printer ...

In forum How do I print this? (Printing help)

3 months ago
@grabnerwggmail-com Since it will feed by hand then it may b...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 months ago
@linden If you flip it back and it still has a problem then ...

In forum General discussion, announcements and releases

3 months ago
Have you tried flipping the steel sheet over to see if it ch...

In forum General discussion, announcements and releases

3 months ago
@hooch Which version doesn't have the problem?

In forum General discussion, announcements and releases

3 months ago
Does the problem go away by reverting back to an earlier ver...

In forum General discussion, announcements and releases

3 months ago
My order for the Mini with filament sensor on 10/30/2020 was...

In forum General discussion, announcements and releases

3 months ago
Have you looked at this article in the help:

In forum General discussion, announcements and releases

3 months ago
The images are missing.

In forum General discussion, announcements and releases

4 months ago
I have seen several comments that window cleaner is all the ...

In forum How do I print this? (Printing help)

4 months ago
Corrected link:

In forum Assembly and first prints troubleshooting

4 months ago
I think PRUSA recommends the powder coated 'satin' sheet as ...

In forum How do I print this? (Printing help)

4 months ago
@craigb I have not been charged a customs charge when it has...

In forum General discussion, announcements and releases

4 months ago
@craigb They charge you when your order is placed. Think of...

In forum General discussion, announcements and releases

4 months ago
Page 1 / 2
Share:

Please Login or Register