Skreelink
Skreelink
Group: Registered
Joined: 2020/10/03
Estimable Member
4
I had similar, at first I thought it was extruder clicks and...

In forum Hardware, firmware and software help

2 days ago
This is the case, every other PLA prints perfectly fine, the...

In forum User mods - OctoPrint, enclosures, nozzles, ...

6 days ago
TL;DR settings at bottom of post. Well, at least for me... I...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 week ago
Initial results seem good, I had a project come up so I have...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 week ago
I have an additional data point to add. The issue is not Pru...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 week ago
@cwbullet How'd it go?

In forum General discussion, announcements and releases

2 weeks ago
@cwbullet Just as a datapoint, if tests are being done, vari...

In forum General discussion, announcements and releases

3 weeks ago
Are you still using the stock heatbreak?

In forum General discussion, announcements and releases

3 weeks ago
Same, hottest filament I have is ASA @ 260.

In forum General discussion, announcements and releases

3 weeks ago
New Hotend Limit

In forum General discussion, announcements and releases

3 weeks ago
It could be! My Mini was orange swapped to green. Here they...

In forum General discussion, announcements and releases

3 weeks ago
@dan-rogers I already have some squash balls from when I got...

In forum General discussion, announcements and releases

3 weeks ago
Well, it's finally here

In forum General discussion, announcements and releases

4 weeks ago
@robee-shepherd It might be sticking to the throat and cooli...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 month ago
As an emphasis on how much this is a Prusament only problem ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 month ago
@cwbullet A slight bump in extrusion multiplier fixed it, my...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 month ago
@cwbullet Also forgot to include some dimensional tests! See...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 month ago
RE: Strange extrusion problem using Bondtech extruder and he...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 month ago
@jonaslevring The settings I used on those Galaxy Black benc...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 month ago
@aurru I did try the lower retractions, and they did show ma...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 month ago
Page 1 / 6
Share:

Please Login or Register