Notifications
Clear all
TheJoyOfPrinting
TheJoyOfPrinting
Group: Registered
Joined: 2020/09/27
Eminent Member
2
@darcshadow This was the exact answer i needed for a differe...

In forum How do I print this? (Printing help)

11 months ago
It’s the nozzle! Good thing I bought 2 this last time! The n...

In forum General discussion, announcements and releases

1 year ago
And it’s clogged again....it cannot be anything other than p...

In forum General discussion, announcements and releases

1 year ago
@tim-m30 The ended 3 pro comes with a very 24 volt fan to co...

In forum General discussion, announcements and releases

1 year ago
@protoncek Thank you! I just decided to wire it right to the...

In forum General discussion, announcements and releases

1 year ago
Yea no response from you would of been 100x better than this...

In forum General discussion, announcements and releases

1 year ago
I’m trying to install my fan but plugging it into the spot y...

In forum General discussion, announcements and releases

1 year ago
@protoncek This is basically my issue atm. I’m doing “smalle...

In forum General discussion, announcements and releases

1 year ago
@protoncek I never would of thought of this! I will definite...

In forum General discussion, announcements and releases

1 year ago
@tim-m30 So they sent 3 tubes. The first one got clogged so ...

In forum General discussion, announcements and releases

1 year ago
Could I have tightened the spring screw too tight and it cau...

In forum General discussion, announcements and releases

1 year ago
The filament is just stuck in the tube. There is no big sect...

In forum General discussion, announcements and releases

1 year ago
@tim-m30 It’s a brand new printer. Doesn’t even have 50 hour...

In forum General discussion, announcements and releases

1 year ago
RE: Filament stuck in the hot end

In forum General discussion, announcements and releases

1 year ago
@tim-m30 There is a tube inside the hot end.

In forum General discussion, announcements and releases

1 year ago
Filament stuck in the hot end

In forum General discussion, announcements and releases

1 year ago
Filament suck in the hot end Boden tube!

In forum Hardware, firmware and software help

1 year ago
How loud is your printer?

In forum Hardware, firmware and software help

1 year ago
Probe never low enough

In forum Assembly and first prints troubleshooting

1 year ago
Page 1 / 2
Share: