Notifications
Clear all
Cranberryhiker
Cranberryhiker
Group: Registered
Joined: 2020/09/20
Eminent Member
2
Okay, it's a different print, but adhesion was much, much be...

In forum How do I print this? (Printing help)

10 months ago
Thorough bed-cleaning, check. Going to try the opposite orde...

In forum How do I print this? (Printing help)

10 months ago
Color change adhesion?

In forum How do I print this? (Printing help)

11 months ago
Final report on this issue. I learned on your calibration pa...

In forum Assembly and first prints troubleshooting

11 months ago
Note to self. When washing the plate, be sure to use a dish ...

In forum Assembly and first prints troubleshooting

11 months ago
Another thought - the occurrence coincides with my having in...

In forum Assembly and first prints troubleshooting

11 months ago
Poor adhesion and globs in prints.

In forum Assembly and first prints troubleshooting

11 months ago
Prints pause themselves. When resumed, head moves, but nothi...

In forum Hardware, firmware and software help

12 months ago
Chunking sound during autoload, plus fan off and no extrusio...

In forum Hardware, firmware and software help

1 year ago
Thanks, Steve. And cwbullet, I'd solder (or probably crimp) ...

In forum Hardware, firmware and software help

1 year ago
Installing RaspberryPi 3B+.

In forum Hardware, firmware and software help

1 year ago
Looks good so far. Again, thanks, folks!

In forum How do I print this? (Printing help)

1 year ago
Wow - thanks, everyone for the cascade of advice! It is very...

In forum How do I print this? (Printing help)

1 year ago
@tim-m30 Alcohol - seems always to get rid of any finger-gre...

In forum How do I print this? (Printing help)

1 year ago
Definitely didn't touch the first layer. I alcohol-wash the ...

In forum How do I print this? (Printing help)

1 year ago
Another photograph.  1113200800.jpg

In forum How do I print this? (Printing help)

1 year ago
Glitches in a flat layer...

In forum How do I print this? (Printing help)

1 year ago
Peter, I like your calibration pattern, and am wondering how...

In forum Assembly and first prints troubleshooting

1 year ago
Peter, I did the first layer calibration step immediately af...

In forum Assembly and first prints troubleshooting

1 year ago
I got the Mk3s put together with a couple of predictable and...

In forum Assembly and first prints troubleshooting

1 year ago
Page 1 / 2
Share: