Activity
 
Robin
Robin
Group: Registered
Joined: 2020/09/18
Trusted Member
3
Just use MMU-Single-Mode in PrusaSlicer. When the print star...

In forum Assembly and first prints troubleshooting

23 hours ago
Da Du "seit neustem" schreibst, gehe ich mal davon aus, dass...

In forum Zusammenbau und Fehlersuche bei den ersten Druckversuchen

2 weeks ago
Ist die Düse / der Heizblock sauber?

In forum Zusammenbau und Fehlersuche bei den ersten Druckversuchen

2 weeks ago
For the record: I print PETG on the textured sheet all the t...

In forum How do I print this? (Printing help)

3 weeks ago
What I wrote generally applies to the PINDA adjustment. Rega...

In forum Assembly and first prints troubleshooting

3 weeks ago
Hard to tell, the picture does not show the nozzle... Home t...

In forum Assembly and first prints troubleshooting

3 weeks ago
IR filament sensor calibration (MMU2S) - Prusa Knowledge Bas...

In forum Assembly and first prints troubleshooting

3 weeks ago
Like stewartr said: looks like the IR sensor never reports t...

In forum Assembly and first prints troubleshooting

3 weeks ago
Somebody should really put a pinned thread in this sub-forum...

In forum Assembly and first prints troubleshooting

3 weeks ago
Slicer. Just use the presets for soluble interface or suppor...

In forum Assembly and first prints troubleshooting

4 weeks ago
That's just the normal homing of the idler.

In forum Hardware, firmware and software help

4 weeks ago
You can just add an indicator LED to both of the critical se...

In forum Assembly and first prints troubleshooting

1 month ago
A jsw said, entangled filament is only possible within the f...

In forum Assembly and first prints troubleshooting

1 month ago
Can you trigger the PINDA (check LED or menu->support->...

In forum General discussion, announcements and releases

1 month ago
@hli: Prusa-UI bekomme ich gerade nicht gegoogelt... Was is...

In forum Benutzermodifikationen - OctoPrint, Gehäuse, Düsen, …

1 month ago
RE: Help with first print - No luck at all.

In forum Assembly and first prints troubleshooting

1 month ago
Empfehlung für Touch-Display und Display-Plugin.

In forum Benutzermodifikationen - OctoPrint, Gehäuse, Düsen, …

1 month ago
Any pictures?

In forum How do I print this? (Printing help)

1 month ago
It's always hard troubleshooting at the beginning because th...

In forum Assembly and first prints troubleshooting

1 month ago
As the name suggests the cable supports the power panic feat...

In forum General discussion, announcements and releases

1 month ago
Page 1 / 4
Share:

Please Login or Register