jluvs2ride
jluvs2ride
Group: Registered
Joined: 2020/09/16
Eminent Member
2
@bobstro Hey, I know this thread is a bit old but I just ins...

In forum General discussion, announcements and releases

1 week ago
Did you ever get this figured out? I have a print that is be...

In forum Coronavirus (COVID-19)

1 week ago
@dan-rogers I think he said it just shifted the problem some...

In forum How do I print this? (Printing help)

2 weeks ago
No guesswork involved. The problem as stated was that paint ...

In forum PrusaSlicer

3 weeks ago
@tim-2 i turned off the Don't support bridges feature and go...

In forum PrusaSlicer

3 weeks ago
@tim-2 I have supports turned on everywhere. So the paint on...

In forum PrusaSlicer

3 weeks ago
Paint on supports?

In forum PrusaSlicer

3 weeks ago
@bobstro I'm not usually in that big of a rush.

In forum How do I print this? (Printing help)

2 months ago
@bobstro OK, so I read the article. I would just replace the...

In forum How do I print this? (Printing help)

2 months ago
I always start with a clean build plate. I notice the proble...

In forum How do I print this? (Printing help)

2 months ago
Over extrusion?

In forum How do I print this? (Printing help)

2 months ago
@bobstro LOL!

In forum How do I print this? (Printing help)

4 months ago
Uh, it's actually a Kilt.

In forum How do I print this? (Printing help)

4 months ago
The bed was cool when I took the print off and I cleaned it ...

In forum How do I print this? (Printing help)

4 months ago
No ideas?

In forum How do I print this? (Printing help)

4 months ago
Defects on corners

In forum How do I print this? (Printing help)

4 months ago
OK, so I went back and researched First Layer Calibration. M...

In forum How do I print this? (Printing help)

4 months ago
If my first layer looks good wouldn't that mean my Z is wher...

In forum How do I print this? (Printing help)

4 months ago
Thank you all for your responses. I only used the acetone be...

In forum How do I print this? (Printing help)

4 months ago
Amazon Basic PLA?

In forum How do I print this? (Printing help)

4 months ago
Page 1 / 2
Share:

Please Login or Register