Activity
 
Notifications
Clear all
Baklin
Baklin
Group: Registered
Joined: 2020/09/13
Reputable Member
5
There shouldn't be any need to push ptfe tubes into friction...

In forum Assembly and first prints troubleshooting

3 months ago
I haven't figured that out completely yet. I can't always ch...

In forum How do I print this? (Printing help)

3 months ago
I just hit the spacebar ones in the Title field.

In forum Hardware, firmware and software help

3 months ago
Good to see you got it working again. But does it still sh...

In forum Hardware, firmware and software help

3 months ago
I just had a look at the skirt settings you posted. The skir...

In forum How do I print this? (Printing help)

4 months ago
Good news. The first screw you tighten is the one on the f...

In forum Assembly and first prints troubleshooting

4 months ago
Did you check the hole on the other side where the motor con...

In forum Assembly and first prints troubleshooting

4 months ago
Could you show us a picture like you did but from the unders...

In forum Assembly and first prints troubleshooting

4 months ago
The unload/load happens mostly when the ir sensor in the ext...

In forum Hardware, firmware and software help

4 months ago
This can be done, but doesn't always work for every one. Not...

In forum Hardware, firmware and software help

4 months ago
Could this be a problem with the cables going through the cu...

In forum Hardware, firmware and software help

4 months ago
That is something I had to test for my self. After disconn...

In forum General discussion, announcements and releases

4 months ago
Also have a look at this video. It shows in detail how the M...

In forum Assembly and first prints troubleshooting

4 months ago
The MMU only "kicks into high gear" when the finda sensor de...

In forum Assembly and first prints troubleshooting

4 months ago
Those black tips look wrong to me. Is that burnt filament? (...

In forum Assembly and first prints troubleshooting

4 months ago
Is this with prints sliced for MK3 MMU Single or for a norma...

In forum Hardware, firmware and software help

4 months ago
Prusaslicer changes the temperatures depending on what print...

In forum Hardware, firmware and software help

4 months ago
@parkerdingeldein That is a problem with the filament sens...

In forum Hardware, firmware and software help

4 months ago
So how do you get from here to, say, the Eshop to check you'...

In forum General discussion, announcements and releases

4 months ago
The MK3s has the right sensor, but it has to be moved to the...

In forum Hardware, firmware and software help

4 months ago
Page 2 / 22
Share: