Notifications
Clear all
Thibaut LM
Thibaut LM
Group: Registered
Joined: 2017/03/04
Active Member
1
You could also add code to your ending gcode script to move ...

In forum General discussion, announcements and releases

4 years ago
Hello, yeah i 've the same problem as you. Even with the new...

In forum Assembly and first prints troubleshooting

4 years ago
I tried PLA from Grossite3D.com I earn nothing to say you t...

In forum Others (Archive)

4 years ago
Hello, Did you try to print your benchy with another type ...

In forum Others (Archive)

4 years ago
Step 1: Buy a Raspberry Pi B+ Step 2: Install and configure ...

In forum Others (Archive)

4 years ago
Hi, i'm using only acetone to clean the sheet and it works e...

In forum Others (Archive)

4 years ago
On my mk3 i was concern about that even if i've no problem w...

In forum Others (Archive)

4 years ago
Yeah it could be anything but probably your power supply. On...

In forum Others (Archive)

4 years ago
My mk3 upgrade should arrive any day now, so im not botherin...

In forum Others (Archive)

4 years ago
I used colorfabb XT together with 3dlac on my mk2 for 6 mont...

In forum Others (Archive)

4 years ago
Hey Guys, Just tried XT-CF20 for the first time. Replaced ...

In forum Others (Archive)

4 years ago
The PTFE tube below the bondtech gear is too short. The fila...

In forum How do I print this? (Printing help)

4 years ago
Hi, why not show the time estimation after slicing? You alwa...

In forum Print tips (Archive)

4 years ago
I've also done an enclosure with "ikea hacks" (with the stuv...

In forum Others (Archive)

4 years ago
Hi ! I've the same problem with the ColorFabb XT without ca...

In forum Others (Archive)

4 years ago
Hello, not sur if it's gonna help you but i try ColorFabb nG...

In forum How do I print this? (Printing help)

4 years ago
Hello, for me i'm not having issue so far with the 3.1.2 RC...

In forum General discussion, announcements and releases

4 years ago
Time is shown after g-code is saved. Ok my bad 🙁 Thanks...

In forum Print tips (Archive)

4 years ago
Hey ! i read on the email send to prusa owner that the time ...

In forum Print tips (Archive)

4 years ago
Share: