PrusaTester2020
PrusaTester2020
Group: Registered
Joined: 2020/08/31
Trusted Member
3
Guys thank you for suggestions 🙂 1. @neophyl: Turned retra...

In forum PrusaSlicer

1 week ago
Spiky edge on low slope surface caused by retraction

In forum PrusaSlicer

1 week ago
@cwbullet After reading the posts and if I have to summarize...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 month ago
I used a brass in the past. Later replaced it with a copper ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 month ago
So the next suspect is the Prusament PLA with some unknown i...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 month ago
Previous year I received a few answers from Bondtech and the...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 month ago
@michaelaswood I was sure that changing the filament would n...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 month ago
I am pritty sure the Mini heatbreak will print it the same W...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 month ago
I am using flawlessly the Prusa one. I will not change it un...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 month ago
@michaelaswood As I see you already have the problem that I ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 months ago
I'm sorry I did not manage to help you 🙁 I read the post an...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 months ago
@pinkie-pie did you use Bondtech heatbreak OR the PRUSA one ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 months ago
I replaced just the Bondtech heat break with the original on...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 months ago
I also think it's something connected to heatcreep. Waiting ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 months ago
I was very tempted to replace the Z-Axis motor but: If it wa...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 months ago
I replaced both the thermistor and the heater but the proble...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 months ago
I used the same code for Pause/Resume and the behavior is th...

In forum General discussion, announcements and releases

2 months ago
May be Christmas and New Year holidays. Also may be other us...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 months ago
@mathias720 Bondtech replaced my heatbreak so it's not a bad...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 months ago
I am also very satisfied with the Prusa Support. Just write ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 months ago
Page 1 / 5
Share:

Please Login or Register