ignacmc
ignacmc
Group: Registered
Joined: 2020/08/01
Eminent Member
2
@karl-herbert Yes. I believe that this happens to all that u...

In forum User mods - OctoPrint, enclosures, nozzles, ...

4 months ago
@karl-herbert Yes, and during olives installation you need t...

In forum User mods - OctoPrint, enclosures, nozzles, ...

4 months ago
@karl-herbert Exactly as I have always thought... I have own...

In forum User mods - OctoPrint, enclosures, nozzles, ...

4 months ago
@steve-smith I agree with you... seems that I have became on...

In forum User mods - OctoPrint, enclosures, nozzles, ...

4 months ago
You coold even print them. search for “Bowden Collet Clip” o...

In forum User mods - OctoPrint, enclosures, nozzles, ...

4 months ago
Great setup! The original one was 275mm long so following yo...

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 months ago
And the ptfe tube can be only one piece instead of three, wh...

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 months ago
Oppps you are right...Damn They are already shipped. I will ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

6 months ago
Thank you...I already bought 10 a month ago just in case...i...

In forum User mods - OctoPrint, enclosures, nozzles, ...

6 months ago
Yes, the MK3 is not Bowden but Direct, right? So the ptfe tu...

In forum User mods - OctoPrint, enclosures, nozzles, ...

6 months ago
Yes, I got your point....But for my personal taste I prefer ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

6 months ago
I have the original Prusa PTFE and had the olive sliding out...

In forum User mods - OctoPrint, enclosures, nozzles, ...

6 months ago
Good to know. Then i don’t understand why Prusa used brass o...

In forum User mods - OctoPrint, enclosures, nozzles, ...

6 months ago
I would say even more...Capricorn XS has an inner diameter o...

In forum User mods - OctoPrint, enclosures, nozzles, ...

6 months ago
One idea could be to prepare a small Y split cable and conne...

In forum Hardware, firmware and software help

6 months ago
There is always going to be some y offset

In forum General discussion, announcements and releases

6 months ago
RE: Extruder-->Print head PTFE tube couplers replacement

In forum General discussion, announcements and releases

6 months ago
I am also thinking about using a Mosquito clone in the futur...

In forum General discussion, announcements and releases

6 months ago
It also happened to me with a Bondtech extruder...I am going...

In forum Hardware, firmware and software help

6 months ago
Yes I suppose you mean that I have to make a bowden tube as ...

In forum General discussion, announcements and releases

6 months ago
Page 1 / 2
Share:

Please Login or Register