Notifications
Clear all
Danypsi
Danypsi
Group: Registered
Joined: 2017/02/22
Eminent Member
2
I have found that worrying about resin calibration with the ...

In forum Assembly and first prints troubleshooting

3 weeks ago
I recently upgraded SL1 to SL1S. If you look at the paramet...

In forum General discussion, announcements and releases

3 weeks ago
@paanguev I purchased the display from Amazon: ELEGOO 5.5 In...

In forum General discussion, announcements and releases

6 months ago
@fredruggiu I'm sorry for not replying sooner. Part of the ...

In forum General discussion, announcements and releases

8 months ago
I tried, but received the message "the file type is not allo...

In forum General discussion, announcements and releases

9 months ago
@fredruggiu

In forum General discussion, announcements and releases

9 months ago
@fredruggiu Here are stl and f3d files for the frame printed...

In forum General discussion, announcements and releases

9 months ago
About a month ago I started noticing holes in the same spots...

In forum Hardware, firmware and software help

1 year ago
Wow. I must be an early owner (non tester) — this is the fi...

In forum General discussion, announcements and releases

1 year ago
@hamza-b I really like Siraya Tech Blu. It really prints we...

In forum General discussion, announcements and releases

2 years ago
@fookatchu Heat strip has adhesive and sticks to steel plate...

In forum General discussion, announcements and releases

2 years ago
@fookatchu I forgot the coat hanger wire to hold the fans.

In forum General discussion, announcements and releases

2 years ago
@fookatchu Attached are 4 photos of the setup. As I said, it...

In forum General discussion, announcements and releases

2 years ago
@nicolas-rosa Thank you very much. I obviously didn't know ...

In forum General discussion, announcements and releases

2 years ago
I have easily made a heater that fits inside my SL1 using a ...

In forum General discussion, announcements and releases

2 years ago
Hi Nicolas-Rosa, What do you mean, “Now with the new firmw...

In forum General discussion, announcements and releases

2 years ago
As you can read in this short string of comments, there has ...

In forum How do I print this? (Printing help)

2 years ago
I have tried nearly everything I can think of to print with ...

In forum How do I print this? (Printing help)

2 years ago
This is not an uncommon problem. Read the forum titled Bloc...

In forum Others (Archive)

4 years ago
I want to say this again and more clearly: Some of you may h...

In forum Assembly and first prints troubleshooting

4 years ago
Page 1 / 2
Share: