Notifications
Clear all
g monkey
g monkey
Group: Registered
Joined: 2020/07/28
Trusted Member
3
Try using the standard Prusaslicer profile for XT-CF20 and n...

In forum How do I print this? (Printing help)

3 months ago
@swiss_cheese - thanks, but I had already unchecked 'ensure ...

In forum PrusaSlicer

3 months ago
How to get rid of solid infill

In forum PrusaSlicer

4 months ago
@coreyfro I have been printing r/c helis, so I understand t...

In forum PrusaSlicer

5 months ago
PS gives you a breakdown of the time taken to print support/...

In forum General software discussion

5 months ago
I have put a set of the Trinamic QSH4218-51-10-049 on my X a...

In forum User mods - OctoPrint, enclosures, nozzles, ...

6 months ago
I have tried PETG and clear Polymax, and I could never get a...

In forum How do I print this? (Printing help)

6 months ago
@cwbullet - what air temp is required to avoid warping? I m...

In forum General discussion, announcements and releases

6 months ago
Sorry to hear about these problems. I'm no expert as I've b...

In forum General discussion, announcements and releases

6 months ago
@Chocki - which filament are you using?

In forum General discussion, announcements and releases

6 months ago
I'm using Prusament PVB but I don't have a Polysher. How lo...

In forum General software discussion

7 months ago
No, the fan does not increase speed with increasing load. T...

In forum User mods - OctoPrint, enclosures, nozzles, ...

7 months ago
Am I the only one who has tried this stuff? It is still lik...

In forum General discussion, announcements and releases

8 months ago
PVB smoothing

In forum General discussion, announcements and releases

8 months ago
I have not had any fan vibration issues with mine. There is...

In forum User mods - OctoPrint, enclosures, nozzles, ...

8 months ago
This is the same one that I had recommended above. It is we...

In forum User mods - OctoPrint, enclosures, nozzles, ...

8 months ago
@chocki I have only used a PC blend (Prusament or Polymax),...

In forum How do I print this? (Printing help)

8 months ago
I did this last night (and checked for updates), and again j...

In forum PrusaSlicer

8 months ago
Profile for PVB

In forum PrusaSlicer

8 months ago
I may have maligned CA; I’ve gone back and tried it again an...

In forum General discussion, announcements and releases

8 months ago
Page 1 / 3
Share: