Activity
 
Lupin
Lupin
Group: Registered
Joined: 2020/07/26
Trusted Member
3
Mini design has its limitations, we just have to learn to co...

In forum Hardware, firmware and software help

13 hours ago
Use the homing (Auto Home in "Calibration") before you try t...

In forum Hardware, firmware and software help

24 hours ago
Prusa slicer works fine on 5 year old Dell XPS 13, 8 GB RAM,...

In forum General discussion, announcements and releases

1 day ago
So far no problems. First layer calibration run as before, n...

In forum General discussion, announcements and releases

1 day ago
I have 12x12x2 concrete slab, which I covered on both sides ...

In forum General discussion, announcements and releases

3 months ago
There's an article in the net about using high temperatures,...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 months ago
AFAIK Peek and PEI are the only ones you use over 300C for. ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 months ago
@justin-10 Someone has SE Mosquito on Mini, check this out:/...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 months ago
Might be your thumb drive gave up? I would take new thumb dr...

In forum Hardware, firmware and software help

3 months ago
Haven't had problems with 4.3 while printing. I also haven't...

In forum Hardware, firmware and software help

3 months ago
Te Z-axis has enough power, sure. Thread is not so sensitive...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 months ago
I had to go and look this up. Nice design. Looks like it it ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 months ago
Nicely done. Excellent.

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 months ago
It took me a while to notice that some of these problematic ...

In forum Hardware, firmware and software help

3 months ago
NEMA 17 specifies only the motor mount. Electrical specifica...

In forum Hardware, firmware and software help

3 months ago
I just run self test on my Mini. No issues detected. It is w...

In forum Hardware, firmware and software help

3 months ago
And perhaps even this for Firmware: report bugs, request for...

In forum General discussion, announcements and releases

3 months ago
Did you read the README.md? Your question sounds like you di...

In forum General discussion, announcements and releases

3 months ago
Does it really extrude filament? I have always thought that ...

In forum General discussion, announcements and releases

3 months ago
I created bug report for the wrong date on the created dump....

In forum General discussion, announcements and releases

4 months ago
Page 1 / 3
Share:

Please Login or Register