ChillyPenguin
ChillyPenguin
Group: Registered
Joined: 2020/07/26
Trusted Member
3
Have you tried any other prints. Do they have the same bandi...

In forum Assembly and first prints troubleshooting

5 months ago
Where did the g-code come from, was this off the USB stick?

In forum Assembly and first prints troubleshooting

5 months ago
I had similar recently when a small piece of filament broke ...

In forum Assembly and first prints troubleshooting

5 months ago
@lumir-p The `clicking` needs further investigation. it coul...

In forum Hardware, firmware and software help

5 months ago
Is the surface that its sitting on resonating? I have mine o...

In forum Hardware, firmware and software help

5 months ago
Take a look at this help article: All your properly neede...

In forum Assembly and first prints troubleshooting

5 months ago
@rockytoptim Check out your Profile page:it contains more ...

In forum General discussion, announcements and releases

5 months ago
The Prusa knowledge base is real very good, I find Google th...

In forum Hardware, firmware and software help

5 months ago
Why is no one asking the important question. Will the XL s...

In forum General discussion, announcements and releases

5 months ago
Something does not look quite right, have you modified or re...

In forum Hardware, firmware and software help

6 months ago
It does seem unnecessary. What annoys me is that when you ...

In forum General discussion, announcements and releases

6 months ago
@hannes-b3 My current procedure appears to be: Set it to the...

In forum General discussion, announcements and releases

6 months ago
Any Mobile App developers, Idea for Prusa Connect Mobile

In forum User mods - OctoPrint, enclosures, nozzles, ...

6 months ago
LoL, sounds like me on the UPS site when mine was in transit...

In forum General discussion, announcements and releases

6 months ago
@gordon-w "sub-optimal" I like that way of putting it. Is ...

In forum General discussion, announcements and releases

6 months ago
@charles-h13 I think you are probably right that "flawed" is...

In forum General discussion, announcements and releases

6 months ago
Proof Prusa knew the Mini was flawed

In forum General discussion, announcements and releases

6 months ago
@steve-4 Worth setting up an address reservation on your DHC...

In forum General discussion, announcements and releases

6 months ago
Sorry, only just spotted this tread. This was pretty much th...

In forum General discussion, announcements and releases

6 months ago
@charles-h13 Due to the high cost of the acrylic, I have opt...

In forum User mods - OctoPrint, enclosures, nozzles, ...

7 months ago
Page 2 / 4
Share:

Please Login or Register