ChillyPenguin
ChillyPenguin
Group: Registered
Joined: 2020/07/26
Trusted Member
3
Please add your issues to the Prusa Github, as that is where...

In forum General discussion, announcements and releases

2 months ago
@remington My solution was to block NTP at the router. Por...

In forum Hardware, firmware and software help

3 months ago
Have faith, let it finish. It will be fine. It's just that t...

In forum How do I print this? (Printing help)

3 months ago
Yes, it works. Just uses a standard USB to Micro USB cable. ...

In forum Hardware, firmware and software help

3 months ago
I believe that Wireless and the additional functional for Pr...

In forum Hardware, firmware and software help

3 months ago
OK, not quite what you are looking for. But I have just publ...

In forum Hardware, firmware and software help

3 months ago
@sm26 No, not using Octoprint, though I have tried it 😀 Wai...

In forum User mods - OctoPrint, enclosures, nozzles, ...

4 months ago
I found the same, lifted mine from 0.8mm to 1.2mm otherwise ...

In forum General discussion, announcements and releases

4 months ago
The link might be nice!

In forum General discussion, announcements and releases

5 months ago
Save the project as am "3mf" file. This is just a compressed...

In forum PrusaSlicer

5 months ago
Here are the instructions in the Knowledge base:

In forum General discussion, announcements and releases

5 months ago
I don't see why not. Does Octoprint support filament sensors...

In forum General discussion, announcements and releases

5 months ago
@3dprintedgr The picture in the store only shows 3 wires, sa...

In forum General discussion, announcements and releases

5 months ago
As I understand it the Mini will not require new firmware to...

In forum General discussion, announcements and releases

5 months ago
Its called marketing 😉

In forum Assembly and first prints troubleshooting

5 months ago
You properly would not be able to see after you have done it...

In forum Hardware, firmware and software help

5 months ago
I was hoping to recycle mine into a filament sensor, FINDA s...

In forum General discussion, announcements and releases

5 months ago
MINDA as a filament sensor

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 months ago
@mog I also ordered two rolls of Prusament, it would have be...

In forum General discussion, announcements and releases

5 months ago
SuperPINDA on order already 😉

In forum General discussion, announcements and releases

5 months ago
Page 1 / 4
Share:

Please Login or Register