Notifications
Clear all
ChillyPenguin
ChillyPenguin
Group: Registered
Joined: 2020/07/26
Trusted Member
3
Please add your issues to the Prusa Github, as that is where...

In forum General discussion, announcements and releases

8 months ago
@remington My solution was to block NTP at the router. Por...

In forum Hardware, firmware and software help

9 months ago
Have faith, let it finish. It will be fine. It's just that t...

In forum How do I print this? (Printing help)

10 months ago
Yes, it works. Just uses a standard USB to Micro USB cable. ...

In forum Hardware, firmware and software help

10 months ago
I believe that Wireless and the additional functional for Pr...

In forum Hardware, firmware and software help

10 months ago
OK, not quite what you are looking for. But I have just publ...

In forum Hardware, firmware and software help

10 months ago
@sm26 No, not using Octoprint, though I have tried it 😀 Wai...

In forum User mods - OctoPrint, enclosures, nozzles, ...

11 months ago
I found the same, lifted mine from 0.8mm to 1.2mm otherwise ...

In forum General discussion, announcements and releases

11 months ago
The link might be nice!

In forum General discussion, announcements and releases

11 months ago
Save the project as am "3mf" file. This is just a compressed...

In forum PrusaSlicer

11 months ago
Here are the instructions in the Knowledge base:

In forum General discussion, announcements and releases

11 months ago
I don't see why not. Does Octoprint support filament sensors...

In forum General discussion, announcements and releases

11 months ago
@3dprintedgr The picture in the store only shows 3 wires, sa...

In forum General discussion, announcements and releases

11 months ago
As I understand it the Mini will not require new firmware to...

In forum General discussion, announcements and releases

11 months ago
Its called marketing 😉

In forum Assembly and first prints troubleshooting

11 months ago
You properly would not be able to see after you have done it...

In forum Hardware, firmware and software help

11 months ago
I was hoping to recycle mine into a filament sensor, FINDA s...

In forum General discussion, announcements and releases

11 months ago
MINDA as a filament sensor

In forum User mods - OctoPrint, enclosures, nozzles, ...

11 months ago
@mog I also ordered two rolls of Prusament, it would have be...

In forum General discussion, announcements and releases

11 months ago
SuperPINDA on order already 😉

In forum General discussion, announcements and releases

11 months ago
Page 1 / 4
Share: