Notifications
Clear all
Marco3712
Marco3712
Group: Registered
Joined: 2020/07/21
Active Member
1
@ssill2 I sadly dont own a flat one anymore as my old one is...

In forum Assembly and first prints troubleshooting

3 months ago
@tim-2 @ssill2 I Have tried multiple times with unoerfumed d...

In forum Assembly and first prints troubleshooting

3 months ago
@ssill2 I clean the plate whenever it stops sticking and fli...

In forum Assembly and first prints troubleshooting

3 months ago
Prints not sticking o right front side no matter what

In forum Assembly and first prints troubleshooting

3 months ago
@tim-m30 Cold pulls was one of the first things I did (hence...

In forum Hardware, firmware and software help

9 months ago
@tim-m30 Hey sorry for taking my time to respond as I have n...

In forum Hardware, firmware and software help

9 months ago
@dingo-aus ok so after putting in the heatbreak I still get ...

In forum Hardware, firmware and software help

9 months ago
@dingo-aus thank you for the help just ordered a standard e3...

In forum Hardware, firmware and software help

9 months ago
@tim-m30 yes thank you it does seem like it is abit more wid...

In forum Hardware, firmware and software help

9 months ago
3D printer partially clogging followed by clicking then comp...

In forum Hardware, firmware and software help

9 months ago
@joantabb Yes just made sure and I did buy the 24 volt heate...

In forum Hardware, firmware and software help

1 year ago
@karl-herbert When pressing preheat the heatbed starts warmi...

In forum Hardware, firmware and software help

1 year ago
Hotend Heater not working

In forum Hardware, firmware and software help

1 year ago
Share: