Notifications
Clear all
Chicago Keri
Chicago Keri
Group: Registered
Joined: 2020/07/12
Trusted Member
3
Considering the hassle a loose E3D hotend cleanup causes, it...

In forum Assembly and first prints troubleshooting

20 hours ago
Yes, if you use an E3D thermistor you will either need the E...

In forum Hardware, firmware and software help

6 days ago
I just did some double-checking of resistance readings on so...

In forum Hardware, firmware and software help

3 weeks ago
RE: A possible cause

In forum Hardware, firmware and software help

3 weeks ago
I solved my similar crunchy sound by re-installing the Noctu...

In forum Hardware, firmware and software help

3 weeks ago
SuperPinda on MK2.5S

In forum General discussion, announcements and releases

3 weeks ago
Hi! Having upgraded my MK2s to a MK2.5s I have some impressi...

In forum General discussion, announcements and releases

4 weeks ago
Been using the Mosquito on a MK2.5s for quite some time now…...

In forum User mods - OctoPrint, enclosures, nozzles, ...

4 weeks ago
Yes, the MK3S+ X carriage seems identical to the MK2.5S one,...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 month ago
Hi Chris What kind of bed material are you using? I always ...

In forum Assembly and first prints troubleshooting

1 month ago
The Nature of Fuses and the 12v Prusa Mk2s - Mk2.5s

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 month ago
Odd, it sounds like it should have worked ok. The E3D is a p...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 months ago
Hi Kenour An E3D Hotend is a pain to assemble! It is not onl...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 months ago
Good idea to buy a spare MiniRambo board while they're avail...

In forum Hardware, firmware and software help

2 months ago
I was thinking about adding a limit switch to a Mk3s+ x-axis...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 months ago
I had a similar crunchy sound that was the 40mm hotend fan....

In forum Hardware, firmware and software help

3 months ago
That does seem strange. I can't think of which parts you mig...

In forum General discussion, announcements and releases

3 months ago
I believe these are the Molex 3953x series or Eurostyle ESE3...

In forum Hardware, firmware and software help

4 months ago
You could move the Y axis limit switch backward or modify th...

In forum Assembly and first prints troubleshooting

4 months ago
Hot End Heater wiring crimping techniques and Thermal Runawa...

In forum General discussion, announcements and releases

4 months ago
Page 1 / 4
Share: