Notifications
Clear all
Thomas Lynch
Thomas Lynch
Group: Registered
Joined: 2020/07/08
Active Member
1
Thanks for the input. I only use and have APPLE computers. ...

In forum General discussion, announcements and releases

3 weeks ago
Check out FilamentPM.com They are the distributor of filamen...

In forum General discussion, announcements and releases

3 weeks ago
Clemens, thanks for the tip. I probably should do this. Howe...

In forum General discussion, announcements and releases

4 weeks ago
I just solved my problem. I should have thought of this befo...

In forum General discussion, announcements and releases

4 weeks ago
I am in deep trouble here. If I format the card I will Proba...

In forum General discussion, announcements and releases

4 weeks ago
Sorry , It only shows the GCODE files that have been sliced ...

In forum General discussion, announcements and releases

1 month ago
Let me explane better. I just sliced 3 files and added them ...

In forum General discussion, announcements and releases

1 month ago
Access to files on SD card

In forum General discussion, announcements and releases

1 month ago
Yes, this has happened to me. The problem is that the scroll...

In forum General discussion, announcements and releases

4 months ago
Another Success

In forum General discussion, announcements and releases

6 months ago
I have the same problem. It started just a short while ago. ...

In forum Hardware, firmware and software help

12 months ago
Spacing the IR sensor off of the mount about .5+mm solved th...

In forum Assembly and first prints troubleshooting

1 year ago
This sounds just like my problem. I'll give it a try as soon...

In forum Assembly and first prints troubleshooting

1 year ago
AutoLoad does not work

In forum Assembly and first prints troubleshooting

1 year ago
Share: