Activity
 
Notifications
Clear all
Bill H
Bill H
Group: Registered
Joined: 2020/07/07
Eminent Member
2
Ok good advice. I'll stop using the Prit Stick What about Is...

In forum Assembly and first prints troubleshooting

9 months ago
Well I’m happy with that, maybe slightly low but hey Ho. ...

In forum Assembly and first prints troubleshooting

9 months ago
Tried again today. Pre Heated the printer using the Prusa PL...

In forum Assembly and first prints troubleshooting

9 months ago
So just wash the sheet, does this refer to the smooth magnet...

In forum Assembly and first prints troubleshooting

9 months ago
Can anyone update me on the above, ref nozzle heights? Do I ...

In forum Assembly and first prints troubleshooting

9 months ago
Did this in a bit of a rush and it's a little confusing (my ...

In forum Assembly and first prints troubleshooting

9 months ago
But when I took it off of the heat bed, the diagonals are al...

In forum Assembly and first prints troubleshooting

9 months ago
Here is the finished calibration print?  IMG_9778.j...

In forum Assembly and first prints troubleshooting

9 months ago
Sorry just found the live adjust setting. It just beeped at...

In forum Assembly and first prints troubleshooting

9 months ago
Sorry nube here, I have downloaded and started to print the ...

In forum Assembly and first prints troubleshooting

9 months ago
And here  thumbnail_image0.jpeg

In forum Assembly and first prints troubleshooting

10 months ago
Z Offset is now -1.02mm and seems to be adhering ok, but now...

In forum Assembly and first prints troubleshooting

10 months ago
Hi, Z Level set at -1.095mm  D7A00A83-F50F-40EF-8057...

In forum Assembly and first prints troubleshooting

10 months ago
That was the over extruded bit, here’s the rest. Maybe it po...

In forum Assembly and first prints troubleshooting

10 months ago
And here’s a close up, what do you think?  D5BD1A5A-...

In forum Assembly and first prints troubleshooting

10 months ago
I ran the PRUSA logo test print and apart from the first few...

In forum Assembly and first prints troubleshooting

10 months ago
The PINDA is definitely higher, just ran the test again and ...

In forum Assembly and first prints troubleshooting

10 months ago
Filament Extrusion Test Failure - Hot End Too High

In forum Assembly and first prints troubleshooting

10 months ago
The first place I saw PTFE mentioned was in step 30 which is...

In forum Assembly and first prints troubleshooting

10 months ago
Anyone?

In forum Assembly and first prints troubleshooting

10 months ago
Page 1 / 2
Share: