Activity
 
Notifications
Clear all
CvK
CvK
Group: Registered
Joined: 2017/02/15
Active Member
1
It was a loose connection, eventually also causing this... ...

In forum Hardware, firmware and software help

1 month ago
I had this problem also just this week. I think it’s likely ...

In forum Hardware, firmware and software help

1 month ago
I'm having this problem, 5 lights flashing at unload/99% don...

In forum Hardware, firmware and software help

2 months ago
Hi All, I'm having the same problem, on the second layer af...

In forum Hardware, firmware and software help

3 years ago
Thank you, Lance, for reminding me of this open topic/post/t...

In forum Assembly and first prints troubleshooting

3 years ago
I'm getting this also after 2 months after upgrading to the ...

In forum Hardware, firmware and software help

3 years ago
Ok. Below is the default start code in Slic3r version 1.37.1...

In forum Others (Archive)

4 years ago
Single Mode Prime Fail: Extruder 1 always trying to prime

In forum Others (Archive)

4 years ago
I have this problem also. The MMU in single mode fails to pr...

In forum Others (Archive)

4 years ago
Have you read through this thread: Peter Thanks Peter, ...

In forum Others (Archive)

4 years ago
Hi guys, After taking your advice, I dropped temps to 190 a...

In forum Others (Archive)

4 years ago
Most likely cause: blockage due to stringing. See this thre...

In forum Others (Archive)

4 years ago
Were these pre-sliced Benchy's or ones you sliced? I used ...

In forum Others (Archive)

4 years ago
Failing or Missing Layers; Stepper Problem or Slic3r?

In forum Others (Archive)

4 years ago
Share: