Alex Hung
Alex Hung
Group: Registered
Joined: 2020/07/03
Trusted Member
3
@skreelink That was the second attempt. The first time the d...

In forum How do I print this? (Printing help)

3 months ago
@skreelink The ASA filament arrived couple of days ago and I...

In forum How do I print this? (Printing help)

3 months ago
@youngatheart2001 You’ll need to setup VPN for your home net...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 months ago
@karl-herbert Mine is all set to “Auto” and works just fine

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 months ago
@prolix21 If only Capricorn sells pre-cut strip of tubing fo...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 months ago
According to Fillamentum data sheet for Extra Fill, print te...

In forum How do I print this? (Printing help)

3 months ago
@dave-h-2 If you worry about hitting the z height adjustment...

In forum How do I print this? (Printing help)

3 months ago
Judging from the benchy picture, I think you can lower the z...

In forum How do I print this? (Printing help)

3 months ago
@karl-herbert Thanks for the suggestion. I’ve already ordere...

In forum How do I print this? (Printing help)

3 months ago
@skreelink I have a silicone sock as well so it should work ...

In forum How do I print this? (Printing help)

3 months ago
@skreelink I may start with ASA as it is easier to print, an...

In forum How do I print this? (Printing help)

3 months ago
@karl-herbert Thanks for the head up. I'm only printing a fa...

In forum How do I print this? (Printing help)

3 months ago
@skreelink PolyMaker PolyMax seems to fit the bill

In forum How do I print this? (Printing help)

3 months ago
@skreelink Officially the MINI doesn't support PC but I'm su...

In forum How do I print this? (Printing help)

3 months ago
@skreelink Good point about the direction of the cooling fan...

In forum How do I print this? (Printing help)

3 months ago
@karl-herbert Wera is my favorite, along with Knipex.

In forum General discussion, announcements and releases

3 months ago
@karl-herbert Good quality tools are a must. Also a Torx key...

In forum General discussion, announcements and releases

3 months ago
Uneven parameter quality?

In forum How do I print this? (Printing help)

3 months ago
@towlerg I’ve considered doing something like this because P...

In forum PrusaSlicer

3 months ago
If it is just a tilt in the x-axis, there's a knowledge base...

In forum Hardware, firmware and software help

3 months ago
Page 1 / 5
Share:

Please Login or Register