Notifications
Clear all
patrick.v2
patrick.v2
Group: Registered
Joined: 2017/02/11
Active Member
1
@bigalky maybe. just telling you this setup is being used si...

In forum User mods - OctoPrint, ...

2 years ago
I also found out that when there is too less resin in the ta...

In forum Assembly and first prints troubleshooting

2 years ago
Have the same problem - power panic is not working

In forum Hardware, firmware and software help

2 years ago
SL1 mobile table

In forum User mods - OctoPrint, ...

2 years ago
Hi all, got an answer from support that I share with you: It...

In forum Assembly and first prints troubleshooting

2 years ago
No space left on device

In forum Assembly and first prints troubleshooting

2 years ago
thanks! was too easy ;o)

In forum PrusaSlicer

2 years ago
SL1: how to add new material profiles in PrusaSlicer ?

In forum PrusaSlicer

2 years ago
update: I upgraded the firmware of the SL1 to 1.2.2 and made...

In forum How do I print this? (Printing help)

2 years ago
I have the same issue printing a rectangular box (40x30x10mm...

In forum How do I print this? (Printing help)

2 years ago
@julien-k Yes, all feet on the table and printer perfectly l...

In forum Assembly and first prints troubleshooting

2 years ago
I found out the pre-heat (before starting the drying) is dis...

In forum General discussion, announcements and releases

2 years ago
@area51 I'll keep my spray cans then 😉

In forum General discussion, announcements and releases

2 years ago
Gold / Silver resin ?

In forum General discussion, announcements and releases

2 years ago
I have another question regarding the drying operation: it d...

In forum General discussion, announcements and releases

2 years ago
I totally agree with that

In forum General discussion, announcements and releases

2 years ago
I discovered that curing is not activated by default, only d...

In forum General discussion, announcements and releases

2 years ago
Failed first layer and resin volume sensor - strange

In forum Assembly and first prints troubleshooting

2 years ago
Share: