Notifications
Clear all
the-sh1z
the-sh1z
Group: Registered
Joined: 2020/06/17
Active Member
1
abs clogged in ptfe, changed ptfe but hotend will not go ove...

In forum Hardware, firmware and software help

1 year ago
@jsw from GA, usa, but now live in NC. got another issue. fi...

In forum Assembly and first prints troubleshooting

2 years ago
taulman nylon 230 vertical screw printing issues

In forum Assembly and first prints troubleshooting

2 years ago
@jsw I like cura and will probably swap over as my primary, ...

In forum Assembly and first prints troubleshooting

2 years ago
@neophyl i managed to get some at amazon. thank you! im amaz...

In forum Hardware, firmware and software help

2 years ago
@jsw Cura does not do this but the over all print quality is...

In forum Assembly and first prints troubleshooting

2 years ago
@neophyl I looks for silicone sock with no luck. Would you m...

In forum Hardware, firmware and software help

2 years ago
bare thermister wires from factory?

In forum Hardware, firmware and software help

2 years ago
@jsw im running out of tuning ideas and patience. everything...

In forum Assembly and first prints troubleshooting

2 years ago
speed settings  Capture.PNG

In forum Assembly and first prints troubleshooting

2 years ago
the issue i print benchy theres a transition band from thinn...

In forum Print tips (Archive)

2 years ago
@jsw Thanks so much for your input! I will try the draft shi...

In forum Assembly and first prints troubleshooting

2 years ago
first benchy prints with hatbox abs have strange artifact

In forum Assembly and first prints troubleshooting

2 years ago
i gave up on the priline. i ordered some saintsmart tpu sinc...

In forum How do I print this? (Printing help)

2 years ago
I am trying print a small tire at this point since the duck ...

In forum How do I print this? (Printing help)

2 years ago
Thank you the print came out much better. There were some ve...

In forum How do I print this? (Printing help)

2 years ago
@joantabb Joan, Thanks so much for your suggestion. I am a g...

In forum How do I print this? (Printing help)

2 years ago
@ben-p13 Do you have any recommendation for which presets pl...

In forum How do I print this? (Printing help)

2 years ago
Mk3s settings to use for black priline tpu

In forum How do I print this? (Printing help)

2 years ago
Share: