Prusa3D Forum

rockytoptim

Group: Registered

Joined: 2020/06/15

Trusted Member

	I believe that is saying the left side of bed is lower than... In forum General discussion, announcements and releases	3 weeks ago
	@fernando-t-2 What does the bed visualizer show? In forum General discussion, announcements and releases	3 weeks ago
	@fernando-t-2 I have done it plus there is 12 pages in that ... In forum General discussion, announcements and releases	3 weeks ago
	@tankertech I had some 0.2mm layer 50 mm x 50 mm squares fro... In forum User mods - OctoPrint, enclosures, nozzles, ...	4 weeks ago
	@tankertech I used a small engineering square to check betwe... In forum User mods - OctoPrint, enclosures, nozzles, ...	4 weeks ago
	I have bondtech extruder and heat break. First run the firs... In forum General discussion, announcements and releases	3 months ago
	@chillypenguin I found the same, I had to raise mine up so z... In forum General discussion, announcements and releases	3 months ago
	@gordon-w I can confirm that the MINDA/SPINDA on my warranty... In forum General discussion, announcements and releases	3 months ago
	@karl-herbert I got a SPINDA as xz axis warranty. It arrive... In forum General discussion, announcements and releases	3 months ago
	@cwbullet I guess I should have said I usually use the Powde... In forum General discussion, announcements and releases	3 months ago
	@cwbullet Where the MINDA would be affected by tempurature a... In forum General discussion, announcements and releases	3 months ago
	I agree with Daniel and Alex. If you moved heater block up ... In forum Assembly and first prints troubleshooting	3 months ago
	I would recommend getting some PLA filament (If you didn't p... In forum General discussion, announcements and releases	3 months ago
	My upgrade order with the SPINDA is scheduled for delivery T... In forum General discussion, announcements and releases	3 months ago
	@benji, Thanks for adding picture of where the the point is ... In forum User mods - OctoPrint, enclosures, nozzles, ...	3 months ago
	@karl-herbert Thanks Karl-Herbert In forum General discussion, announcements and releases	3 months ago
	So I just got my XZ Axis today from prusa as a warranty repl... In forum General discussion, announcements and releases	3 months ago
	@bapski My guess would be able to run more than 1 filament. ... In forum General discussion, announcements and releases	3 months ago
	@ dakoda84 You don't need to flash custom firmware for warm ... In forum Hardware, firmware and software help	4 months ago
	@withey89 I did contact them they told me the dev's were wor... In forum Hardware, firmware and software help	4 months ago

Page 1 / 4 Next

Forum Statistics

397 Forums

36.3 K Topics

264.9 K Posts

77 Online

40.5 K Members

Latest Post: Selbsttestprobleme Our newest member: Tom Drought Recent Posts Unread Posts Tags

Forum Icons: Forum contains no unread posts Forum contains unread posts Mark all read

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed