steve.w4
steve.w4
Group: Registered
Joined: 2017/02/03
Eminent Member
2
At what point does it again check tension? Seems that if I ...

In forum Assembly and first prints troubleshooting

3 years ago
I slowed infill down the 45mm/s and that resolved the issue....

In forum Others (Archive)

3 years ago
Slow down the infill speed a little bit works well for me. ...

In forum Others (Archive)

3 years ago
I am printing and testing different infill patterns and came...

In forum Others (Archive)

3 years ago
PETG and renticular fill

In forum Others (Archive)

3 years ago
What is the number? Some tension, frequency? (My book only h...

In forum Others (Archive)

3 years ago
I made the mistake of starting an 11 hour print BEFORE upgra...

In forum Others (Archive)

3 years ago
My guess would be that the retraction settings are inaccurat...

In forum Others (Archive)

3 years ago
With RC5, I did not have infill problems with 15% honeycomb ...

In forum Others (Archive)

3 years ago
My guess would be that the retraction settings are inaccurat...

In forum Others (Archive)

3 years ago
Are you running the same speeds as RC4? RC5 disabled Linear ...

In forum Others (Archive)

3 years ago
New firmware print issues with Infill

In forum Others (Archive)

3 years ago
Im using a hardend steel nozzle from E3D, i cannot see any d...

In forum Others (Archive)

3 years ago
also have to be careful how much you tighten it. They su...

In forum Others (Archive)

3 years ago
320 mm. That, I had to look at my Misumi order PSFJ8-320/330...

In forum Others (Archive)

3 years ago
I was able to print PETG without any problem until the FW/SW...

In forum Others (Archive)

3 years ago
That is how it fit when I put the hot end in on my parts as ...

In forum Others (Archive)

3 years ago
It has gotten a little better in the latest firmware, but be...

In forum Others (Archive)

3 years ago
There is another thread on this, but essentially Update the...

In forum Others (Archive)

3 years ago
Page 1 / 2
Share:

Please Login or Register