Notifications
Clear all
Protoncek
Protoncek
Group: Registered
Joined: 2017/02/01
Reputable Member
5
Tiny bubbles also appear when printing ABS. Usually they dis...

In forum How do I print this? (Printing help)

10 months ago
Hm... this page: says quite opposite: textuded plate is NOT...

In forum How do I print this? (Printing help)

10 months ago
Same here. If i remember i’ve had problems with shifting lcd...

In forum User mods - OctoPrint, enclosures, nozzles, ...

10 months ago
Well, i dont' quite understand how 2.2mm wide filament CAN g...

In forum Hardware, firmware and software help

11 months ago
Joan, thanks for explanation. I didn't have problems with or...

In forum Hardware, firmware and software help

11 months ago
I wonder why prusa decided to change heatbreak for their pri...

In forum Hardware, firmware and software help

11 months ago
@jhopke: I connected fan parallel with filament sensor, it'...

In forum General discussion, announcements and releases

12 months ago
There's a version of this case with side blowing on my link ...

In forum General discussion, announcements and releases

12 months ago
I also tried to change retraction in a way that printer does...

In forum General discussion, announcements and releases

12 months ago
Yes, i do have printer in enclosure, because i print PETG an...

In forum General discussion, announcements and releases

12 months ago
I never measured temperature, but it was hot to touch, too h...

In forum General discussion, announcements and releases

12 months ago
I’ve had heatsink mounted first, too (even bigger than yours...

In forum General discussion, announcements and releases

12 months ago
I've had similar problems (with PLA mostly). Since i instale...

In forum General discussion, announcements and releases

12 months ago
Just for octoprint even 1GB is quite enough (used ram never ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 year ago
I agree, it's not an issue. It's just that i find much easie...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 year ago
Well, for update printer must reboot. Connecting through USB...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 year ago
I did, although on Pi4. It works, but i went back to USB bec...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 year ago
Well, you obviously live (or work) in a very clean environme...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 year ago
Sure, fans can be practically silent (if you use expensive o...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 year ago
Fans are to be avoided if not really necesarry. Fans die. Fa...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 year ago
Page 1 / 15
Share: